1

2008. 01

AVL USER GUIDE (GSM)Automatic Vehicle Locator Manual

Korea 위치정보통신 www.sos007.co.krTEL: +82-2-333-2505FAX: +82-2-333-5885E-mail: pos0987@naver.comMobile:+82-10-7396-6669

2

Components Specifications Remark

CPU / Solution ARM 7TDMI, MediaTek Solution

MEMORY ROM( Flash memory) 16Mbyte, SDRAM 4Mbyte

SMART GPS

SiRFstarIII GSC3f/LPx (Active antenna available) - Low power consumption, High performance - Position Accuracy : < 2.5m, <2.0m(SBAS)

-TTFF : < 1 sec(Hot Start), < 35 sec(Warm/Cold Start)

GSM Modem

GSM Quad-band(850/900/1800/1900 MHz),

GPRS (Class 12, included TCP/IP)

Internal battery Available ( Optiona1)

Interface

10 Pin I/O

- Included Main Power, 1 Serial Port, 1 Emergency Button,1 engine restart

prevention.

1 Audio Port ( Mic/Speaker, Optional)

Power Supply 12~30V DC

OthersMaterial : Aluminum

Reverse voltage prevention diode, over-voltage prevention component.

Vehicle Control Unit AVL (GSM/GPRS)

1-1) Product Introduction

1. Product Introduction

3

Index Function Remark

LBS Function

1. Enter a restricted area alarm function - If the vehicle enter a restricted area, report to center 2. Immediate location tracking function - If it received the requiring locations at once, report location information to center 3. Report last stop( engine stop) location to center - If the vehicle’s engine stop, report location and engine stop information to center 4. Updating server ( control center ) information - The device is updated server information( address, etc.) by SMS command5. Report current setting information to center - The device report device setting values( server address, cycle time, etc) to center 6. Report self-test results to center - The device report result of device’s self-test to center 7. Emergency button - If it occurred emergency situation, report to center immediately 8. Detect vehicle engine start - If vehicle start engine, report to center 9. Prohibit vehicle engine start - If vehicle set prohibit restart engine by control center, Driver can not start engine 10. Block-box function - Store tracking location information in included memory 11. Detect cut off GPS antenna function -If someone remove a GPS antenna, report to center .

Optional Function

1. Include Li-ion battery( Optional 400mAh battery) -If someone remove a vehicle battery, report to center using included battery2. Intercept audio in car function. - it can Intercept audio by center. (Optional microphone )

1-2) Product Detailed specification – LBS Functions

1. Product Introduction

4

Linked to the GPS Antenna

Linked to the GSM Antenna

Linked to the Main

Connector

GPS Signal LED

GSM Signal LED

Power Signal LED

Plug SIMCARD

Front side Back Side

1-1) Product Function switch-a

Linked to Mic/Spearker

2. Product Function

5

Pin Num

Define I/O Type Mark

1 B+ Input Vehicle battery + ( 10 ~ 30V)

2 IGN InputVehicle ignition signal sensing port Device power on when this signal is high

3Emergency Switch

Input Emergency Switch Input

4 Uart Tx Output Serial interface TX (RS232) - Optional

5 Ground GroundVehicle Battery Ground (common ground) - Optional

6 Ground Ground Vehicle Battery Ground

7Aux Output-01

Output Auxiliary Output Port - Optional

8 ST_Control OutputImmobilizer, Re-start prevention function

9 Uart Rx Input Serial interface Rx (RS232) - Optional

10 Out_power output12V / 5V (factory setup) (Max 1A@5V) - Optional

5 4 3 2 1

10 9 8 7 6

Main Connector Pin Define

2-2) Product Function switch-b

LED Color Define

Power LED (RED)

1. LED Off: Power Off2. LED On: Power On3. LED Blink at intervals of 0.5Sec : Main battery (B+) power line is disconnected

Modem LED (Green)

Green LED indicates the status of GSM/GPRS modem1. LED On: Normal operation2. LED Blink at intervals of 1 Sec: Network search3. LED Blink at intervals of 0.5 Sec : Limited or No service state

GPS LED (Yellow)

Yellow LED indicates the status of GPS1. LED On: Satellites found and location fixed,2. LED Blink at intervals of 1 Sec : Invalid GPS data, position not fixed3. LED Blink at intervals of 0.5 Sec: GPS wire disconnection4. LED Off: GPS Module Power Off

LED Function Define

Power GSM GPS

LED Indicator

Main Connector

2. Product Function

6

5 4 3 2 1

10 9 8 7 6

3-1) Product Installation – Main Cable

a. Main Cable Connection

3. Product Installation

Pin Num Define Color I/O Type Mark

1 B+ Red Input Vehicle battery + ( 10 ~ 30V)

2 IGN Yellow Input

Vehicle ignition signal sensing port Device power on when this signal is highEx) . Connect to Battery of Vehicle or . Connect to ignition signal of Vehicle

3 Emergency Switch Blue Input Emergency Switch Input

4

5 Ground Block Ground Vehicle Battery Ground (common ground) - Optional

6 Ground White Ground Vehicle Battery Ground

7

8 ST_Control Green Output Immobilizer, Re-start prevention function

9

10

7

3-1) Product Installation – Main Cable

b. Main Cable Connect to Vehicle

3. Product Installation

AVL

CarBattery

RED

RED

White

Yellow

Blue

Black

Connect to Relay

Emergency Button

GSM Antenna

GPS Antenna

Green

Connect to Ignition Line

(ACC / Start)

It will be power ON the device when the Yellow line be supplied power(12V)

Test or Always System

power On

8

3-2) Product Installation– Antenna

GSM Antenna

GPS Antenna

3. Product Installation

9

3-3) Product Installation– SIMCARD

Push-Push Type SIM Card Socket

3. Product Installation

10

On Off

• Back Side Battery power SW - This switch must be on for the device operation.

3-4) Product Installation– Internal battery On

3. Product Installation

11

1) Product Block Diagram

4. Product Diagram

GSM RFGPS Module

(SRF III)

GSM Main Processor

Memory(Flash/Sdram)

GSM Quad Band

Antenna

GPS Active

Antenna

Uart/Reset

/Antenna Detector

Power Block(Input to 5V)

From Vehicle Battery 12~24V

GSMPower Block

Multi Port Power Supplier

From Vehicle Ignition Signal

Battery

Slide SW

GPS Debug

Port

GSM Debug

Port

GPS D/L Slide SW

Emergency Button

Photo Coupler

Photo Coupler

Cut Restart to Vehicle

Detector

Low VoltageAudio Port

12

1) Product Function – Board Picture

5. Product Function

Debug Port

Battery Connector

GPS D/L SW: Normal Operation: GPS F/W Download

Power Block

GSM Block

13

1) Product H/W Detailed specification

Index Descriptions

Form Factor Blok-Box Type, AVL (Automatic Vehicle Location) System

Band Quad Band GSM 850,900,1800,1900, GPS

GPS SiRF Star III

Dimension 12.6 x 90.0 x 21.2 mm ( W x L x H )

Antenna Dual Internal (Active GPS / Bar type GSM )

Weight About g((Include standard battery)

Speaker/Mic 3 Pol Interface port

O.S Memory 128 / 32 ( FLASH / SDRAM)

Data TCP/IP, GPRS Class-12, Circuit-switched Data

SMS MT/MO

Battery 490 mAh -Optional

Interface 10Pin Main Connector, 3-Pol Audio Port

Emergency button

Provide external Emergency button ( Cable Type)

LBS Feature Over the Air Terminal (AVL) Control : - SMS, TCP/IP

Auto Detect Auto detect functions : Low Battery, Cut Battery, Cut GPS Ant.

3 LED Indicator States indicator of GPS, GSM, Power

General Specification

Index Descriptions

Storage Temperature -40 C to +85 C

Operation Temperature • -30 C to +65 C

Operating Humidity up to 80%

Environment Specification

GPS Specification

Index Descriptions

SolutionSirfstarIII GSC3f/LPx50MHz ARM7TDMI processor plus 1Mbit SRAM / 4Mbit flash

Position Accuracy

Normal < 2.5m

SBAS < 2.0m

TTFF

Time To First Fix

- Hot Start : < 1 sec

- Ward/Cold Start : < 35 sec

SensitivityAcquisition -142 dBmTracking -159 dBm

3 LED Indicator

States indicator of GPS, GSM, Power

Power Consumption

Index Descriptions

Consumptions for mode

Idle mode < 3mA GPS Off, GSM standby mode Normal mode 100 ~ 250mA GPS + GSM Rx/Tx Operation Max Operation 350mA

Internal Battery ( 490mAh Battery)

- Standby time : 160 hours GPS Off, GSM standby mode - Operation Time : 2.5 ~ 4.5 Hours Continual tracking mode

6. Product H/W Specification