+12v Constant = Yellow/black +12v Acc. Switch = Yellow -12v Chassis Ground= Black +12v Illumination = Red +12v Dimmer =Antenna/Amp Remote =Pink Can-Bus =

LF+ = GreenLF- = Orange

RF+ = Green RF- = Orange LR+ = Black LR- = Yellow RR+ = Brown RR- = White

Dash Type : Double DinAftermarket: Single/Double dinKit: KA2072B/KA2069BHarness: HY07BAntenna: Std. Motorola

About the Vehicle

Make: KiaModel: SedonaYear: 2006-09

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Rear

Kia Sedona2006-09

NOTES

Dimensions: Lower Door

Dimensions: W= L= D=

NOTES

Rear Side Panels: 6x9'' MidbassSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 Torx screws securingspeaker.

Standard/OptionalCD PlayerMP3 CompatibleRear DVD EntertainmentInfiniti Sound System

Ampli�er Locations: Under driver’s seat. W= 5.5'' L= 5.5'' D= 3.5''

Type: Standard Audio System Location: At Speakers

Speaker Sizes

INFINITI sounds system: 6 1/2" speaker in rear panel replacing the 6x9" 8" sub in left rear quarter panel.

A Pillar: 1'' TweeterLower Door: 6 1/2” MidrangeSpeaker Adapter: SAU56Speaker Harness: TBAFactory Assembly: (4) Phillips head Screws securingspeaker to adapter.

Kia Sedona

Images

Front Speakers

Radio removal

Front Speakers

Rear Speakers

1. Using a PRT extract the bezel surrounding the shifter.2. Using a PRT unsnap the dash bezel surroundingthe radio.3. Extract (1) PHS securing each air vent panel.4. Using a PRT unsnap and remove air vent panels.5. Extract (4) PHS securing factory A/C control panel.6.Extract (4) PHS securing radio to dash.

Radio

Recommended: Disconnect negative battery cable

A Pillar1. Remove (1) PHS behind SRS air bag badge on the "A" Pillar.2. Using a PRT unsnap "A" pillar and pull up and out to remove.3. Extract (2) screws to remove tweeter.

Rear Side Panels1.Remove trunk rear runner panel, and extract (1) PHS from each end.2. Extract (2) 14mm seat belt bolts3. Extract (2)10mm hex bolts located in floor jack compartment.4. Using a PRT unsnap the entire rear panel.5 Extract (4) T20 torx securing the factory speaker.

Rear Speakers

Front Door1. Extract (3) PHS along the perimeter of the doorpanel.2. Extract (1) PHS located inside the door handle.3. Extract (1) PHS located in the door handle release cup.4. Using a PRT unsnap the perimeter of the doorpanel.5. Lift away disconnect and remove.6. Extract (4) PHS securing factory speaker tospeaker adapter.

2006-09