2007 grand prix wheel bearing rear
TRANSCRIPT
![Page 1: 2007 Grand Prix Wheel Bearing Rear](https://reader036.vdocuments.net/reader036/viewer/2022080209/552790d34a795946118b4713/html5/thumbnails/1.jpg)
Wheel Bearing/Hub Replacement - Rear
Removal Procedure
Important: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.
1. Raise and suitably support the vehicle. refer to Vehicle Lifting. 2. Remove the tires and wheels. 3. Remove the brake rotor.
Rear Wheel Speed Sensors
4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped. 5. Remove the mounting bolts from the rear bearing/hub (4).
Zoom Sized for Print
![Page 2: 2007 Grand Prix Wheel Bearing Rear](https://reader036.vdocuments.net/reader036/viewer/2022080209/552790d34a795946118b4713/html5/thumbnails/2.jpg)
6. Remove the wheel bearing/hub (3) and the backing plate (2).
Installation Procedure
Zoom Sized for Print
Zoom Sized for Print
![Page 3: 2007 Grand Prix Wheel Bearing Rear](https://reader036.vdocuments.net/reader036/viewer/2022080209/552790d34a795946118b4713/html5/thumbnails/3.jpg)
1. Install the backing plate (2) and the wheel bearing hub (3). Notice: Refer to Fastener Notice in Service Precautions.
2. Install the wheel bearing/hub-to-knuckle bolts. Tighten the bolts to 75 N.m (55 lb ft).
Rear Wheel Speed Sensors
3. Install the ABS electrical connector to the wheel speed sensor (1), if equipped. 4. Install the brake rotor and caliper. 5. Install the tires and wheels. 6. Lower the vehicle.
Zoom Sized for Print