Do not pour leftover paint into drain. Leave in pail for safe disposal.

Use in a well ventilated area, wearing eye and face protection.

Pail must be stored upright with lid tightly closed.

If product is swallowed, seek medical advice.

In case of eye contact, rinse with clean water and seek medical advice.

Do not re-use pail to store food or drink.

Keep away from children.

For full product information, application procedure and safety information, call 603-8024 1399.

Lotasil Paints Sdn Bhd 1070165 - V

23 Jalan TS 6/8 Taman Industri Subang USJ 1

47510 Subang Jaya Selangor DE, Malaysia. T +603 8023 8532 F +603 8023 8237 E enquiry@lotapaints.com

www.lotapaints.com

RESPONSIBLE CARESURFACE PREPARATION

APPLICATION

ADVANTAGES

SAFETY PRECAUTIONS

12062014

Surfaces to be coated must be prepared according to Lotasil Guide Specifications.

All surfaces must be clean and dry before application.

Old metal roofs with rusty surfaces must be prepared by brushing and cleaning

off rust particles. One coat of approved anti-corrosion paint to be applied.

All screws must be applied with A-COOL Silicone Patching Compound. All holes

to be patched by fibre glass matt or chopped strand fibre glass.

A-COOL Silicone Waterproofing Membrane is applied in one or two coats

depending on requirements or application methods.

Application by brush is preferable over roller because of better surface levelling.

Use a large brush attached to a short extension pole for easy application.

Application by spray equipment is allowed. Contact Lotasil Technical Support

for information.

1 Mixing : Mix product slowly with paddle mixer to ensure product is

homogeneously mixed. Do not whip up bubbles with strong mixing.

2 Thinning : Product is ready to use. Should thinning be required, please check

with Lotasil Technical Support.

3 Primer : Primer is optional unless otherwise required. Substrate adhesion test

will determine requirement of Primer.

4 Application : Apply with brush for one thick single coat for best levelling effect

or with spray equipment. Apply 1 coat and allow to cure preferably 5-7 hours

or overnight. Reapply second coat if required.

Allow product to cure for 12-48 hours before using for light foot traffic.

5 Clean Up : Clean brushes and rollers with solvent thinner, white spirit or

otherwise please refer to Lotasil Technical Support.

As a moisture curing product, the cured product exhibits excellent long term resistance when exposed to natural weathering including temperature fluctuations, ultraviolet radiation, rain with negligible change in product elasticity.

The product can be applied by way of spray, roller or brush. Application of 1 single thick coat by brush is sufficient for most cases.

Silicone Membrane is slippery when in contact with water after rainfall. Precautions must be taken to ensure proper safety precautions are undertaken especially when roofs are higher than low pitch.

EXTERIOR

A-Cool Silicone Waterproofing MembraneMetal Roof 505 MR/LE

TECHNICAL DATA SHEET

EXTERIOR

A-COOL Silicone Waterproofing MembraneMetal Roof 505 MR/LE

TECHNICAL DATA SHEET