series

www.jettacorp.com

Jetta guarantees that the water temperature in our insulated whirlpool baths will stay within 2 degrees of its original temperature after 30 minutes of use. Our fully insulated whirlpool baths with low density foam insulation and passive warm air induction systems help keep you warmer, longer.

to order or for more information, call 1-800-288-7771 for the authorized representative in your area

Options Available:• Air Option

• Mood or LED lights

• Bath waste & overflows

• Decorator colors

• Contoured neck support pillow

• Jetted neck pillow

• Aromatherapy

• 6" acrylic grab bars

Colors Available:• White, Bone, Biscuit (Standard Colors)

• Sandbar, Mexican Sand, Black, Ice Grey (Decorator Colors)

Trim Kit Finishes Available:• Polished Brass

• Polished Chrome

• Oil Rubbed Bronze

• Satin Nickel

Operating Gallons (approx.):• Regular Usage - 70 gal.

• Upper Body Usage - 100 gal.

Features:• 19 flow-adjustable and directional jets including:

• 6-pack & 3-pack rotating back jets

• 3 hip jets • 4 foot jets • 3 side jets

• Two 2 B.H.P. pumps - 9.5 Amps each

• 2 Tri-ssage Controls for distinct pump flow rates

• High gloss / high impact acrylic in standard colors

• Totally insulated with polyurethane foam

• Rotating back jets are adjustable to stationary jets

• Upper body jets can be shut down for operation at a

lower water level.

• Silent passive warm air induction system

• Drain back technology for sanitary bathing

• 10-year limited factory warranty

• Anti-microbial flex piping

• Extra thick glassing

• Pre-leveled lip

• Slip resistant bottom

• Energy efficient

• Noise absorption

60" x 60" x 25" - CORNER - 2 PERSON

Cabana (J-22XP)

This two-person corner tub is the ultimate Bathing Experi-ence. Accommodating eventhe tallest person, theCabana gives each bather their own back and foot massage.

© 2014 Jetta Corporation. All rights reserved. Specifications are subject to change without notice. REV 10/2014

Jetta CorporationTechnical Specifications

www.jettacorp.com© 2014 Jetta Corporation. All rights reserved. Specifications are subject to change without notice. REV 10/2014

*Pump position L/S will extend a minimun of 2” beyond edge of bath. Separate location required for air blower.

Electrical Specifications:Required Electrical Service 110/115 VoltsStandard Whirlpool 20 amp GFIAir Option 20 amp GFIEach pump and blower must be protected by a dedicated GFI breaker (refer to local codes).

Codes/Standards Applicable:Specified model meets or exceeds the requirements for the following standards:UL Listed, ANSI, ASME

Suggested Pump & Blower Access Panel: Suggested access size 20" x 12".Actual size may vary depending on distance ofaccess to pump & blower location.

Drop-In Cut Out Dimension:Subtract 1” from width and length dimensions.

Shipping Weight: 330 lbs.

Cabana (J-22XP)60" x 60" x 25"

*Stand facing tub to determine pump and blower location.

**Air option adds 1.5” to tub height.Components may extend beyond tub rim.

(R/F)

64 ¾”

**Air option adds 1.5” to tub height.Components may extend beyond tub rim.

60”

62”

53”39”

48”

14”

45”

28”

60”

19 ½” **

23 ¼” **

21 ¼” **25 ¼” **

7”

84 ½”

(R/S)(L/S)

34 ¼”34 ¼”

Optional Air Blower

(R/S)

Pump(L/S)

Pump(R/S)

Installation: Measure tub before building tub deck. For best results, Jetta Corporation recommends

1”-3” of mortar bedding under the tub base for maximum support. Drawing shows manufacturer’s standard

pump location(s). Optional location(s) available at an additional cost depending on feasibility. Contact Jetta for

details. Dimensional variance on drawings may be +/- 1/2 inch and are subject to change without notice.