7.1 gravity erosional forces. i.erosion and deposition a.erosion – process that wears away surface...

13
7.1 Gravity EROSIONAL FORCES

Upload: sienna-union

Post on 15-Dec-2015

214 views

Category:

Documents


0 download

TRANSCRIPT

7.1Gravity

EROSIONAL FORCES

I. Erosion and DepositionA. Erosion – process that wears away surface

materials and moves them from one place to another.

B. Major causes – gravity, glaciers, wind, and waterC. Deposition – dropping of sediment in a new

location.a. The final stage of erosion.

II. Erosion and Deposition by GravityA. Gravity – force of attraction that exists between all

objectsB. Gravity causes loose materials to move down a

slope.C. Mass Movement – erosion that occurs due to

gravitational pull on a down slope.

D. Slumpa. Slump- mass movement that happens when loose materials

or rock layers slip down a slope.

b. Happens when layers underneath can not support the rock and sediment above.

E. Creepa. Creep – sediments that slowly inch their way down a hill.

b. Frequent in areas of freezing and thawing

F. Rockslidesa. Large blocks of rock break loose form a steep slope ad start

tumbling

b. Occur in mountainous areas or where there are steep cliffs

c. Most often happen after heavy rains, or during earthquakes

G. Mudflowsa. Occur in dry areas where there are thick layers of dry

sediments

b. Often after a heavy rain

III. Erosion-Prone LandA. Building on Steep Slopes

a. Prone to slumps because of weak sediment layers underneath.

b. Removal of vegetation or increasing slope speeds up erosion.

B. Making Steep Slopes Safea. Plant vegetation

b. Build walls or terraces

c. Can only slow erosion, never eliminate

Pg. 189 1-4

7.2Glaciers

EROSIONAL FORCES

I. Continental and Valley GlaciersA. Weight of snow becomes great enough to press

the bottom layers into ice.B. Pressure on ice on the bottom causes partial

melting and becomes putty-like.C. Glacier – moving mass of ice and snow.D. Continental Glaciers

a. Glaciers covered up to 28% of Earth during the last ice age (2 to 3 million years ago)

b. Average air temperature was 5 degrees C lower than today.

c. 20,000 years ago ice sheets began to melt.

d. Today glaciers only cover 10% of Earth.

E. Valley Glaciersa. Occur in current climate in high mountains where

temperature is low enough to stop snow from melting.

b. These glaciers grow and creep along.

II. Glacial ErosionA. Glaciers pull loose material and deposits it in a

new location.B. Plucking - Glacial ice melts and water flows into

crack in rocks. As it refreezes rocks break apart and results in boulders, gravel, and sand being added to the moving glacier.

C. As the glacier moves, plucked rock fragments rub against soil and bedrock speeding up erosion.

D. The rocks leave grooves or striations.

E. Evidence of valley Glaciersa. In mountains look for striations and plucking.

b. Valley glaciers make bowl-shaped basins called cirques.

c. Two or more glaciers will form arete, a ridge, or a horn.

d. Glaciers erode valley in U-shapes

III. Glacial DepositionA. Till

a. Till – different size sediment dropped from a melting glacier.

b. During the last ice-age glaciers dropped till in the northern United States to fill valleys and make land appear flat.

c. Moraine – ridge formed when a glacier stops moving and a large amount of till is dropped

B. Outwasha. More snow melting causes glacier to melt and retreat.

b. Outwash – material left by the meltwater

c. Meltwater leaves sediments and deposits in layers like a river

d. Can make fan-shaped deposits.

e. When meltingwater under a glacier forms a river in the ice, eskers, a winding ridge of sand and gravel is formed.

Pg 196 1-3

7.3Wind

EROSION FORCES

I. Wind ErosionA. Deflation and Abrasion

a. Deflation – blowing loose sediment, removing small particles such as clay, silt, and sand.

b. Abrasion – windblown sediments strike rock, and wear away the surface.

c. Abrasion and deflation happened mainly in deserts, beaches, and plowed fields.

d. Abrasion works like sandblasting, with the wind acting as the machine.

B. Sandstormsa. Sandstorm – low cloud, just above the ground

b. Occur in deserts and sometimes on beaches and dry riverbeds

C. Dust Stormsa. Dust storms – higher off the ground and can be carried far

distances

b. Storms blow top soil from open fields, overgrazed areas, and place where vegetation has disappeared.

II. Reducing Wind ErosionA. Windbreaks

a. Rows of trees used to reduce the energy of motion in wind to stop soil erosion

B. Rootsa. Plants with fibrous root systems, help to stop erosion

III. Deposition by WindA. Loess

a. Loess – glacial outwash of fine-grained sediments, deposited by wind

b. Creates much of the fertile farmland of the Midwestern US

B. Dunesa. Formed when sediments build up behind an obstacle

b. Build where there is sand and winds or sea breezes that blow daily.

c. Sand builds up becoming an obstacle itself

d. Sand will continue to build and form a dun until the sand runs out or the obstacle is removed.

C. Dune Movementa. Side facing wind has gentler slope, side away is steeper

b. Without grasses, dunes will migrate form the direction of the wind

D. Dune Shapea. Shape can tell the direction of the wind

b. In a crescent shaped dune, the points are directed downwind.