8mm FRAMELESS CONCEALED HINGE 2 DOOR QUADRANT

VictoriaPlum.com0344 804 48 48

Refer To Sheet 9 For Relevant Product Codes

1

BEFORE YOU START, HERE IS SOME IMPORTANT INFORMATION

1) General Information

2) Additional Notes

Please inspect this product upon delivery any missing parts or manufacturing,

defects must be reported immediately to the supplier. Damage or defects reported

later will not be accepted. TAKE CARE WHEN HANDLING GLASS PARTS - AVOID

HEAVY CONTACT BETWEEN THE GLASS EDGES AND ANY HARD SURFACE.

Glass breakage claims will not be accepted after the product has been unpacked.

Please note: Aluminium is a soft metal, and undergoes a series of extrusion,

fabrication, polishing and anodising processes in order to create your finished

shower enclosure. Some light surface marks are normal, and is a result of the

manufacturing processes. Quality control has ensured that this item is of a good

standard, and is fit for purpose.

Please read these instructions carefully before starting installation.Special care should be taken when drilling walls to avoid hidden pipes or electrical cables.

Note: this product is heavy and may require two people to install.

TOOLS REQUIRED

This product is heavy and may require two people to install.

Ø3mm Drill bit

Ø6mm Drill bit

Pencil

Spirit level

Tape measure

DESCRIPTION DESCRIPTIONPART IMAGE PART IMAGE

Drill

Flat-headScrewdriver

Cross headScrewdriver

Mallet

Silicone Sealant

PZ1

(1) 2x Wall Profile Top Caps L&R

(2) 2x Wall Profiles

(3) 2x Wall Profile Cover Strips

(4) 10x Wall Plugs

(5) 2x Fixed Panels

(6) 2x Fixed Panel Seals

(7) 10x Screws (ST4x30)

(8) 1x Bottom Seal A

(9) 1x Bottom Drip Strip

(10) 2x Bottom Strip Caps L&R

(11) 1x Bottom Seal B

(12) 2x Moving Panels

(13) 2x Moving Panel Seals

(14) 6x Screws (ST4x12)

(15) 4x Hinges

(16) 2x Upright Profile Caps

(17) 2x Wall Brackets

(18) 2x Glass Clamps

(20) 2x Top Bars

(19) 18x Screw Caps

(21) 2x Magnet sSeal

(22) 2x Handles (Supplied Separately)

2

3

THESE DIMENSIONS ASSUME THE WALLS ARE PLUMB AND THE SHOWER TRAY IS LEVEL, AND THAT THE WALLS ARE TILED DOWN TO THE TOP OF THE TRAY USING A 10mm TILE/WET WALL PANEL.

ASSEMBLY INSTRUCTIONSIf you require help, we advise you to contact a competent plumber

FITTED TWO DOOR QUADRANT DRAWING

Installation Steps

900

90

0

20

20

4

Step 1 DRILLING WALL PROFILE TO THE WALL

Step 2 FITTING THE FIXED PANEL

0~20mm

2 x8

ø6.0mm

4

3

x8

x8

St4x30

1

2

x2

x2

1

10mm

5

Step 3 ASSEMBLING THE HINGES + MOVING PANEL

Step 4 FITTING THE MAGNET SEALS

inside

Fixed Panel

inside

Moving Panel

outside

1 2 3 4x4 x4 x4 x4

1

2

6

Step 5 SECURING THE COVER STRIP CLIPS

Step 6 FITTING THE BOTTOM DRIP STRIP

ø3.0mm

St4x12

1

2

x6

x6

1

3

2

4

outside

7

Step 7 FITTING THE WALL BRACKETS + TOP BAR

Step 8 FITTING THE TOP CAPS, COVER STRIP, SEALS AND HANDLE

ø6.0m

x21

3

x2

4x2 x2

5 6x2 x2

outside

12mm 15mm

12mm

outside

15mm

x4

St4x30

1

2

3

4

5 (Handles Supplied Separately)

outside

6

2

8

Step 9 SILICONE THE OUTSIDE EDGES

Allow 24 hours for silicone to dry before use. Silicone on the

outside edge only, NOT THE INSIDE

24 hours

9

CARE AND MAINTENANCE

COMMITMENT TO QUALITY

1) AFTER CARE INSTRUCTIONS

2) MAINTENANCE

Regularly clean your shower product with warm soapy water

Clean the plastic parts with a cloth and mild detergent. Never

use any abrasive creams, dissolvents, acetone or detergents

and disinfectants that contain chlorine. The supplier acceptsno liability for any type of use of care other than those contained

in these instructions. The supplier reserves the right to introduce

technical changes without notice.

It is our intention that the quality and functions of this productare of the highest standard. If you require help we advise you

firstly contact a competent plumber. However we understand that

this may not always be the case, so should you experience

any problems please contact our customer services quoting

the following:

Product name: 8mm Frameless Hinge 2 Door Quad

Product code: LHQD902 / LHQD902BLK

Customer help line number: 0344 804 48 48

to prevent lime scale build up. Do not use abrasive cleaning

fluids or materials, or strong chemical cleaners as this will

damage the product surface.

INSTALLERS NOTES

10

The packaging you have received with your product is 100% recyclable.It must be disposed of in a safe and environmentally friendly way.

We suggest you take it to the local landfill site and discard in the designated bins.

V02/09 2017/

Victoria Plum Limited, Bridgehead Business Hessle, HU13 0DG

Park

17

EN 14428:2015

DOP No.:J170810001-1

Shower enclosures with aluminiumprofiles and safety glass

Essentialcharacteristics

Performance Harmonisedtechnical

specificationCleanability

Impactresistance/shatter

properties

Pass

Pass

PassDurability

Clause 4.2 of EN 14428:2015

Clause 4.3 of EN 14428:2015

Clause 4.4 of EN 14428:2015