1002528

89.272267.4

1.2531.8

1.2531.8

50.741288.7

1.0025.4

1.0025.4

4.46113.3

2.2156.3

1.3233.5

4.18106.1

AC INLET(IEC C14)

1.0326.2

10.33262.4

23.6600

23.6600

15.7400

3.94100.0

32.82833.7

13.56344.4

.8020.4

10.32262.2

1.0326.2

5.01127.2

5.01127.2

.8020.4

8X M8X1.25 THREADS15mm DEEP

CABLE CLAMP ATTACHMENT POINTS

SPEAKERS

A

OPS SLOT

KEYPAD

32.82833.7

23.62600.0

1.4236.0

HANDLES

2X LIFTING EYEBOLTS63mm (2.5in) OD, 35mm (1.4in) ID

450kg (992.1 lbs) MAX LOAD EACH

TOP VIEW

BOTTOM VIEW

DETAIL ASCALE 1 : 2

HDMI 1 (4K/30Hz)

HDMI 2 (4K/30Hz)

HDMI 3 (4K/60Hz)

HDMI 4 (4K/60Hz)

DP1 (4K/60Hz)

DP2 (4K/60Hz)

VGA

PC AUDIO INIR-INAUDIO OUTSPDIF OUT

RS232 IN

LAN

OPS USB 3.0

OPS USB 2.0

OPS USB 2.0

REVISION HISTORYECO ZONE REV. DESCRIPTION DATE APPR'D

A INITIAL RELEASE 12/7/2018 MRW

B UPDATED EYEBOLT CALLOUT AND ADDED NOTE FOR PANEL LIFTING PROCEDURE 9/16/2019 MRW

12345678

12345678

AA

BB

CC

DD

THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO PLANAR SYSTEMS, INC., ANY REPRODUCTION IN PART OR WHOLE WITHOUT THE WRITTEN PERMISSION OF PLANAR SYSTEMSIS PROHIBITED. THIS DRAWING IS SUPPLIED FOR INFORMATION, IDENTIFICATION, ENGINEERING, EVALUATION, AND/OR INSPECTION PURPOSES ONLY AND MAY NOT BE USED AS BASISFOR THE MANUFACTURING OF PRODUCTS OR THE FURNISHING OF SERVICES TO PLANAR SYSTEMS OR TO ANY THIRD PARTY UNLESS AUTHORIZED IN WRITING BY PLANAR SYSTEMS.

-----------------------------------

TOLERANCES:

ENGR BY

DRAWN BY

CHECKED BY

USED ON

MATERIAL

FINISH

MRW

27NOV18PLANAR SYSTEMS, INC.1195 NE COMPTON DRIVEHILLSBORO, OR 97006 USA

EPX100 998-0869-00TITLE

SIZE

DPART NO.

- DRAWING NO.

EPX100 OUTLINEREV

BSCALE

1:8 DO NOT SCALESHEET

1 OF 1

050-0218-02 REV B

THIRD ANGLE PROJECTION

DIMENSIONING AND TOLERANCING PERASME Y14.5M-1994

UNLESS OTHERWISE SPECIFIEDDIMENSIONS ARE IN MILLIMETERS [INCHES].

= ±1°

XX= ±.25

.X= ±.5

X= ±1

USE SPREADER BAR OR MAINTAIN GREATER THAN 45 IF USING 4.SINGLE POINT LIFT.

PORTRAIT ORIENTATION IS ROTATED 90 CLOCKWISE AS 3.VIEWED FROM THE FRONT.

KEEP PERFORATION AREAS CLEAR FOR VENTILATION.2.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.1.

NOTES: UNLESS OTHERWISE SPECIFIED.