a simple guide to do it yourself roof repairs
DESCRIPTION
Many people see roof repairs as a daunting overwhelming task. Most people would not even contemplate doing roof repairs themselves because of how important the roof is to the home. We are here to tell you that roof repairs can be done by homeowners.TRANSCRIPT
A Simple
Guide To Do
it Yourself
Roof Repairs
Many people see roof repairs as a daunting overwhelming task. Most people would
not even contemplate doing roof repairs themselves because of how important the
roof is to the home. We are here to tell you that roof repairs can be done by
homeowners. All you need is a good budget, the right instructions, and the time to
complete the task. We are here to give you the right instructions to complete a roof
repair you are proud of. We will go over proper diagnostics, basic of clay roof
repair, basics of metal roof repairs, and how to test the roof to ensure things were
completed correctly. To hire professional roofer contact
http://www.reroofingbrisbaneqld.com.au/
Diagnostics
Suspecting a roof problem is one thing, but how can you check to make sure there
is a problem before you go through the trouble of attempting a repair? Here are
things to look for that may mean you have a leak:
Holes in the roof due to fallen debris
Visibly damaged vents mounted on the roof
Missing Tiles
Broken Tiles
Visible Algae due to drainage issues
Known repairs that previously occurred
If you like, you may also call an expert in order to complete the diagnostics to
ensure you are correct in your assessment.
Clay Roof Repairs
First things first, when working on a tile roof rubber sole shoes are mandatory. The
tiles break easily so being careful while performing this repair is necessary. The
rubber sole shoes are important for safety reasons because the tiles can become
quite slippery when wet. The needed materials are as follows:
Preferred Clay Tiles
Hammer
Protective eye equipment
Ladder
Wood Strip (Thin)
Pry Bar
Tile Clips
Each tile will be replaced one by one. Fall protection equipment is a good way to
go, from a safety stand point. The following steps need to be followed for proper
replacement:
1. Step 1 is making sure your ladder is seated well.
2. Step 2 Remove the tile being replaced
a. Lift the corner of the broken tile
b. From underneath gently tap the tile with the hammer until it
breaks
3. To remove the nail use your pry bar
4. Attach tile clips to the center area of where the now missing tile was
seated
5. Replace the tile and remove the wooden wedge
6. Pull the replacement tile down until it catches the tile clip, and you are
all done
Each tile takes about an hour so be realistic on timing allowed for project. Replace
tiles one at a time.
Metal Roof Repairs
Metal roof repairs are completed generally by following these steps:
1. Clean the necessary areas and drains removing any debris
2. Tighten and replace fasteners if needed
3. Power wash roof removing any caked up or powdery rust
4. Apply some form of roof cement to any visible gaps
5. Apply sealant to all fasteners and seams
6. Ensure all gaps around any type of protruding objects are sealed with a form
of roof cement.
Watch this video to know how to repair metal roof where an expert will guide
you to do this
Test It Out
After you do any project make sure you check, check, and check again to ensure
you replaced all of the needed sections.
Keep checking this link http://home.howstuffworks.com/home-
improvement/repair/how-to-repair-a-leaky-roof.htm to know more.
Published by
Masterbuild Roofing Brisbane Address: 32 Turbot Street, Brisbane QLD, 4000, Australia
Phone: 07 3040 8077
Email: [email protected]
Websites: http://www.reroofingbrisbaneqld.com.au/