a stable vertical reference for bathymetric surveying · a stable vertical reference for...
TRANSCRIPT
A stable vertical reference for bathymetric surveying and tidal analysis in the high ArcticThe EM300 multibeam sonar mounted on the Amundsen is one of the prime tools used for marine
geomorphologic and hydrographic investigations as part of ArcticNet. Under reconnaissance conditions, the data, as collected, serve as a valuable source of information even if imperfect. Sources of imperfection generally include bottom tracking degradation due to seastate or ice-conditions, imperfect sound speed information and imperfect calibration but perhaps most significantly the lack of a stable vertical datum. .
The measurements, as routinely collected and currently presented, are strictly with respect to the local water surface. If multiple passes of data, acquired on different missions and at different phases of the tide, are to be used to build up an accurate picture, variations in the long term vessel elevation due primarily to tide, but also due to draft changes (due to loading, squat and trim) have to be properly backed out. The traditional method used for this has been through the use of a network of tide gauges combined with draft and squat estimates. Such an approach is not practical however in the high arctic as the existing network of water level monitoring stations is too sparse and the existing hydrodynamic models have not yet proven reliable at robust spatial interpolation.
An alternate approach to a stable vertical datum is to adopt the ellipsoid as the reference. Recent advantages in wide-area differential GPS (WADGPS) now allow vertical referencing to within a few decimeters vertically without the need for coastal base stations. With appropriate filtering and use of inertial sensors, the same data can potentially be relied upon for work at the decimeter level. In doing so it completely bypasses the need for draft, trim and squat measurements. As part of an experiment, almost all data acquired so far with the Amundsen has had synoptic measures of the vessel ellipsoid elevation derived using the CNav WADGPS service. This potentially allows us to co-reference the data using a common vertical datum.
A particularly critical application for this will be repetitive monitoring of the seabed instability features (rotational slump fields) to try and detect fine scale changes. An additional byproduct of this technology is that, as long as appropriate draft and squat models are applied, the same data can be used to examine the variations in the phase and amplitude of the tide at locations remote from the existing tides network. This will allow calibration of existing hydrodynamic models, improved confidence in the extrapolation of thegeoid-ellipsoid separation offshore and even perhaps the establishment of viable chart datumsinterpolations for these remote areas.
20cm/km
0
TID
E S
TN
. A
TID
E S
TN
. B
MSL ~= geoid
Sonar-relativeDepth measurement
Chart Datum
(a level below which the water rarely falls)
Instantaneous Water level
Ellipsoid
draught
C-Nav RTG - WADGPS
29-27m
16m9.7m
18.7m
6.3m
5m
3.5m
CNav antenna
RP - IMU
Heavezero-mean
1600Time - JD281 (GMT)
1700 1800 1900
Speed(over ground)
knots
EllipsoidHeight(antenna)
C-Nav RTG metres
8 kn
ots
10 k
nots
13.5
kno
ts
~30cm
~18cm~12cm
Squat Trials7th October 2004
tide falling
John E. Hughes Clarke1, Travis Wert2, Peter Dare1, Jonathan Beaudoin1 and Jason Bartlett3
1: Dept. Geodesy and Geomatics Engineering, University of New Brunswick,2: Mapping and Charting Establishment, DND, Ottawa3: Canadian Hydrographic Service, Burlington Ontario
0.78m
0m
5.6m
0m
M2 and K1 tidal amplitudes (range = 2x)
M2 K1
Mak
kovi
kSu
rvey
Mak
kovi
kSu
rvey
C-Nav Ellipsoid Heights – 1 Hz
EGM96 – predictive model of Ellipsoid-Geoid Separationalong Amundsen shiptrack, Labrador Sea
C-Nav Ellipsoid Height – EGM96 Geoid-Ellipsoid Separation Model
1Hz data (with heave)
60 second averages
Gale 1 Gale 2
Cape Chidley
StraitBelle Isle
N.W. Atlantic ModelM2-S2-N2-K1-O1
Hudson Bay ModelM2-S2-N2-K1-O1- M4-MS4
WebTidePredictions
(3D barotropic F.E. hydrodynamic model)
C-Nav AntennaGeoid Height(Ellipsoid Height,
Reduced using EGM96)
Mak
kovi
kSu
rvey
JD278 JD279 JD280 JD281JD277JD276
33
23
C-Nav AntennaGeoid Height (m)
(Ellipsoid Height,Reduced using EGM96)
WebTidePredictions (m)(3D barotropic F.E. hydrodynamic model)
+5
-5
2004JD2790000Z
26.7
25.7
Makkovik Bank Survey
2004JD2790600Z
2004JD2791200Z
2004JD2781800Z
2004JD2790000Z
2004JD2790600Z
2004JD2791200Z
2004JD2781800Z
C-Nav -1Hz Ellipsoid Heights (m)
C-Nav Ellipsoid Heights – 60 sec. average
E E E E EWWWW
CCGS Amundsen – Speed over Ground (knots)
2004JD2790000Z
2004JD2790600Z
2004JD2791200Z
Labrador Sea Transit - Ungava Bay to Quebec CityA comparison of geoid height observations against WebTide tidal predictions in an area of particularly steep geoid-ellipsoid slopes..
67m
-50m
EGM 96 :Geoid Ellipsoid Separation
5m contours
CCGS AmundsenShiptrack,
July/August 2004
Passing through all three of the WebTide model zones
NorthWest Passage Transit : ArcticNet Leg-9A comparison of geoid height observations
against WebTide tidal predictions.
EGM96 : Geoid-Ellipsoid Separation Model
C-Nav WADGPS – Antenna Ellipsoid Height
2004JD220
2004JD225
2004JD230
2004JD235
Arctic8 ModelM2-S2-N2-K1-O1
Hudson Bay Model
M2-S2-N2-K1-O1-M4-MS4
WebTide Predictions(3D barotropic F.E. hydrodynamic model)
C-Nav AntennaGeoid Height(Ellipsoid Height, reduced using EGM96)
2004JD220
2004JD225
2004JD230
2004JD235
CCGS Amundsen Squat0.0027*pow(sp,1.8)
0
0.1
0.2
0.3
0.4
0.5
0.6
0 5 10 15 20
Speed knots
Squa
t (m
)
ObservationsModel
Geoid-Ellipsoid Separation(EGM96, 1m contours)
Makkovik Bank EM300 Bathymetric SurveySteaming up and down the geoid-ellipsoid slope on the edge of
Labrador margin. A practical application of the use of C-Nav ellipsoid heights as a means of reducing a hydrographic survey. .
WebTidehttp://www.mar.dfo-mpo.gc.ca/science/ocean/coastal_hydrodynamics/WebTide/webtide.html
3 models – Arctic Archipelago – Hudson Bay - NW Atlantic. An independent means of predicting sea surface topography. Obviously does not include non-tidal
variations (storms, river input, seiches, long term barotropic sea surface slopes etc..). Calibrated against existing observed harmonics (M2,S2,N2,K1O1). Can be used as a check on C-Nav geoid height signal.
Antenna height solutions include both water level variations anddraft variations. The draft variations are as a result of long term changes such as loading (fuel and stores consumption, ballast tank trim adjustments etc..) and most significantly hydrodynamic effects due to driving a displacement hull through the water. Field trials using ellipsoid height solutions (these figures) indicate that the vessel squats down an extra 30cm at speeds of 14 knots. As much of the ArcticNet operations involve transit and then sitting on station, this effect must be accounted for.
33
27
33
27
33
26.7
25.7
26.7
25.7
20
02004
JD2781800Z
+5.0
-5.0
23
3323
33
-37
13
-10
40
JD278 JD279 JD280 JD281JD277JD276
JD278 JD279 JD280 JD281JD277JD276
JD278 JD279 JD280 JD281JD277JD276
-50
20
-23
47
23
33
-5
+5
EGM96 – Gradient MapThe ellipsoid-geoid separation surface is generally most reliable in areas of low slope. Estimates of sea-surface topography are most likely to be compromised in areas of rapid geoid undulations. The most notable regions in Canada lie along the east side of Baffin Island and along the Labrador margin (where the Makkovik survey (right-most data set) took place).
The zigzag ellipsoid height profile is a
direct result of 180ºsurvey line azimuth
reversals as the vessel climbs up and down the geoid relative to
the ellipsoid
After removal of the EGM96 ellipsoid-geoid separation
model at the instantaneous vessel location, the residual
profile reflects the vertical motion of the vessel w.r.t. the geoid
as is thus a valid proxy for the tide
With instantaneous
heave
1 minute filter to remove heave
Vessel speed through the water was reduced
with increasing sea state to lower bubble
washdown.The net result being
vessel draft alterations (squat)
The vessel vertical profile w.r.t. the geoid does not
match the predicted WebTide solution.
One possible reason may be a storm
surge associated with the SE gale
underway.
The survey consisted of 9 E-W parallel lines, each around 25 km long, lasting 60-70 minutes, depending on speed
CCGS Amundsen Squat0.0027*pow(sp,1.8)
0
0.1
0.2
0.3
0.4
0.5
0.6
0 5 10 15 20
Speed knots
Squ
at (m
)
ObservationsModel
? long period sea surface anomalies?not accounted for in EGM96
Antenna Geoid Profile
Squat-Adjusted Profile(using squat model)
Final Profile allowing for dynamic draft
67m
-50m
EGM 96 :Geoid Ellipsoid Separation
5m contours
CCGS AmundsenShiptrack,
October 2004