adjustable swivel bather

www.drivedevilbiss.co.uk

Drive DeVilbiss Healthcare LtdHeathfield Lane, Birkenshaw

West Yorkshire, GB BD11 2HWwww.drivedevilbiss.co.uk

Document code: 12490ADJ_HangtagProduct code: 12490ADJ

Issued 09/16

warranty details

Your Drive branded product is warranted to be free of defects in materials and workmanship for one year from date of purchase.

This device was built to exacting standards and carefully inspected prior to shipment. This warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the customer.

In the event of a defect covered by this warranty, we will at our option supply parts or replace the device.

This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear. The warranty does not extend to non-durable components which are subject to normal wear and need periodic replacement.

If you have any queries or require full warranty conditions, please contact your Drive stockist.

specification

The swivel bather is constructed from aluminium tubing and a PE-HD white plastic seat

Overall width 66cm - 71cm (26” - 28”)

Seat dimensions:40cm (D) x 41cm (W) x 8cm (H from top of bath) 16” (D) x 17”(W) x 3” (H from top of bath)

Weight Capacity: 25 stone (160kg)

care and maintenance

! To maintain the quality of the finish, we recommend that the swivel bather is wiped down or showered and dried after each use.

! Periodically clean the bath bench with a damp cloth and mild detergent or disinfectant. Do not use abrasive detergents as these can damage the plastic parts.

! Check that the device swivels easily, smoothly and locks in to place. If the locking mechanism does not feel positive or there is excessive movement in the device, remove from use and contact your dealer.

! Check for cracks and damage to bather, in particular the plastic seat and tubing. Check that the nut underneath the seat is present and secure.

! Do not use in environments over 60ºC (saunas, for example)

safety precautionsApply the following precautions before use:

! Inspect all parts for shipping damage before

assembly. If there is shipping damage - DO NOT

USE. Contact your dealer for further instructions.

! Ensure that all four ‘E’ clips are fully installed on the

traverse arms.

! Check all four corners of the swivel bather are

resting on the top edge of the bath by at least 5cm

(2”). Check that the setscrews are lightly touching

the inside of the bath. Do not overtighten the

setscrews.

! Always sit in the centre of the swivel bather, and do

not lean on the edges of the bather as this can

cause instability. DO NOT stand on the bather.

! Do not exceed the weight limit of 160kg (25 st).

assembly instructions

operation

safety precautions

safety precautionscontents

‘E’ Clips x 4

Traverse Arms x 2

Swivel Seat Unit x 1

1. Insert the traverse arms in the base plate until the required hole is seen in the base plate.

2. Insert the ‘E’ clips into each of the traverse arm tubing to secure.

3. Repeat the process for the otherarm, ensuring all four ‘E’-clips are used

4. Adjust the setscrews so they lightly touch the edge of the bath.

Lift the lever arrowed, and swivel the seat around until it locks in position and is facing the user.

The user should sit on the seat and then lift the lever and swivel the seat whilst lifting their legs to they can use the bath.