7/31/2019 AM 12 Chapter 0

1/4

ANSYS, Inc. Proprietary 2009 ANSYS, Inc. All rights reserved.

April 28, 2009Inventory #002645

Training Manual

ANSYS MeshingApplication Introduction

7/31/2019 AM 12 Chapter 0

2/4

0-2ANSYS, Inc. Proprietary 2009 ANSYS, Inc. All rights reserved.

April 28, 2009Inventory #002645

Training Manual

Inventory Number: 002645

1st Edition

ANSYS Release: 12.0Published Date: April 28, 2009

Registered Trademarks:ANSYSis a registered trademark of SAS IP Inc.

All other product names mentioned in this manual are trademarks or registered trademarks of their respectivemanufacturers.

Disclaimer Notice:This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Reviewand Approval Procedures. This ANSYS Inc. software product (the Program) and program documentation(Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that containsprovisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies,

and other provisions. The Program and Documentation may be used or copied only in accordance with theterms of that License Agreement.

Copyright 2009 SAS IP, Inc.Proprietary data. Unauthorized use, distribution, or duplication is prohibited.

All Rights Reserved.

7/31/2019 AM 12 Chapter 0

3/4

0-3ANSYS, Inc. Proprietary 2009 ANSYS, Inc. All rights reserved.

April 28, 2009Inventory #002645

Training ManualCourse Contents

Chapter 1: Introduction to Workbench

Chapter 2: Meshing Application Overview Chapter 3: Meshing Methods for 3D Geometries

Chapter 4: Common Meshing Application Controls

Chapter 5: Tetrahedral Meshing

Chapter 6: Sweep Meshing Chapter 7: Multizone Meshing

Chapter 8: Meshing 2D Geometries

Appendix A: Mesh Quality

Appendix B: CFX-Mesh

7/31/2019 AM 12 Chapter 0

4/4

0-4ANSYS, Inc. Proprietary 2009 ANSYS, Inc. All rights reserved.

April 28, 2009Inventory #002645

Training ManualCourse Schedule

Chapter 2 Intro to Meshing 9:00-9:45

Workshop 2.1 9:45-10:00

Chapter 3 Meshing 10:00-10:30

Break 10:30-10:45

Workshop 3.1 10:45-11:15

Chapter 4 Common Controls 11:15-12:00

Lunch 12:00-13:00

Workshop 4.1 & Workshop 4.2 13:00-13:30 Chapter 5 Tet Meshing 13:30-13:50

Workshop 5.1 & Workshop 5.2 13:50-14:30

Chapter 6 Sweep 14:30-14:45

Workshop 6.1 & Workshop 6.2 14:45-15:15

Break 15:15-15:25

Chapter 7 Multizone 15:25-15:40

Workshop 7.1 & Workshop 7.2 15:40-16:10

Chapter 8 Surface Meshing 16:10-16:20

Workshop 8.1 16:20-16:40

Appendix Overview 16:40-17:00