cement de-nox application in europe 欧洲水泥工业脱硝应用介绍
Post on 03-Jan-2016
132 Views
Preview:
DESCRIPTION
TRANSCRIPT
CEMENT DE-NOx APPLICATION IN EUROPE
欧洲水泥工业脱硝应用介绍
1) The European Cement Industry欧洲水泥工业现状
Manufacturing Technologies生产技术
Capacity from 1 000 to 5500 t/d
处理能力从 1000 到 5500 t/d
SNCR technology for NOx reduction is applicable on these technologies both dry and wet.
SNCR 脱硝技术同时适用于干法和湿法
Technology 技术类别 Pre Heater Towers 预热塔 Pre Calciner Towers 预分解窑 Lepol Gates 立波尔窑 Long kilns 长转窑
DENOX STATUS行业脱硝现状
• 283 Cement Manufacturing lines (2009)
283 家水泥生产线
• The majority of the plants in West Europe are equipped with SNCR technology
西欧大部分水泥厂都配备 SNCR 系统
• First installations made 20 years ago.
20 年前安装了第一套 SNCR 系统
• One SCR installation
目前仅有一套水泥 SCR 系统
2) The European NOx Legislation欧盟关于 Nox 排放的相关规范
EU directive for Cement Plants not using waste as fuel以非废弃物作为燃料的水泥厂的欧盟指令
1. For plants using dry technology with heat recovery
工厂采用干法(带余热回收)
• 1 200 mg/Nm3 as 24 hours average
2. For plants using half dry technology
工厂采用半干法
• 1 500 mg/Nm3 as 24 hours average
3. For plants using wet or dry technology without heat recovery
工厂采用湿法和干法(不带废热回收)
• 1 800 mg/Nm3 as 24 hours average
EU directive 2000/76/EU for Waste incineration in Cement Plants
2000/76/EU 以废物焚烧水泥厂的欧盟指令FOR PREHEATER & PRE-CALCINER TECHNOLOGY
• For older plants using maximum 40% waste as fuel
使用 40% 以下废物作燃料的现有工厂
• 800 mg/Nm3 as 24 hours average
• Locally more strict rules 当地更严格的法规
2. For newer plants using maximum 40% waste as fuel
使用 40% 以下废物作燃料的新建工厂
• 500 mg/Nm3 as 24 hours average
• Locally more strict rules 当地更严格的法规
3. For all plants using more than 40% waste as fuel
使用超过 40% 以上废物作燃料的工厂
• Local rules pointing at 200 mg/Nm3 as 24 hours average
局部地区更严格规定 24 小时的平均值是 200 mg/Nm3
Typical Type of Waste used使用废物的典型类型
1. Tires
轮胎
2. Plastic fluff
塑料绒毛
3. Waste oils
废油
4. Animal fat
动物脂肪
5. House hold waste
生活垃圾
6. Wood
木材
Future Trend未来的趋势
• Long kilns shall apply 800 mg/Nm3
长转窑应采用 800 mg/Nm3
• Pre heater and Pre calciner Towers shall apply 500 mg/Nm3
预热器和预分解窑应采用 500 mg/Nm3
• Locally more strict rules pointing at 200 mg/Nm3
局部更严格的法规是 200 mg/Nm3
3) The SNCR Process in Cement Plants水泥厂 SNCR 工艺
Two reagents compare 两种还原剂对比
Ammonium hydroxide (NH4OH)氨水• Reaction is more direct
反应更直接• Higher NOx reductions
高效的去除率• Lower ammonia slip
较低氨逃逸• Higher chemical reaction
efficiency较高的化学反应效率
Urea solution ((NH2)2CO)尿素 • Reaction more complex
反应更复杂• Formation of laughing gas ( N2
O )形成笑气 ( 温室气体)
• Lower NOx reductions较低的去除率
• Higher ammonia slip较高的氨逃逸
• Higher CO formation较高的 CO 形成
Effect of the temperature温度的影响
Injection locations is key喷射位置至关重要
Injector itself is key 喷枪的重要性
4) What NOx reduction can be achieved?
能达到的 NOx 去除率?
Urea or ammonium hydroxide?尿素或氨水?
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
Re
du
cti
on
Test
Reduction of the Petro SNCR system with 25% NH4OH / urea solution
Max reduction NH4OH Max reduction with urea
Efficiency (AUF) of the Petro SNCR system with 25% NH4OH / urea solution
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25
Test
Re
ac
tio
n e
ffic
ien
cy
AU
F
Efficiency with NH4OH Efficiency with urea sol.
– 70-90 % NOx reduction possible with SNCR technology using ammonium-hydroxide.
– SNCR 用氨水可达到 70-90% 的 NOx 去除率– 30-40 % NOx reduction possible with SNCR
technology using urea.– SNCR 用尿素可达到 30-40% 的 NOx 去除率– 60-85% chemical efficiency possible with SNCR
technology using ammonium-hydroxide.– SNCR 用氨水可达到 60-85% 的化学效率– 20-40 % chemical efficiency possible with SNCR
technology using urea– SNCR 用尿素可达到 20-40% 的化学效率
Cost saving – example 费用对比 - 举例
Evaluation of the difference in cost using 40% urea / 25% ammonium hydroxide as reagent:40% 的尿素和 25% 的氨水的使用耗量评估•Flue gas flow (烟气流量) : 300.000 Nmc/h @10% O2, dry•NOx baseline (基准值) : 1000 mg/Nmc @10% O2, dry•NOx target (目标值 1 ) : 750 mg/Nmc @10% O2, dry (25% reduction)•NOx target (目标值 2 ) : 450 mg/Nmc @10% O2, dry (55% reduction)•Hours / year (年运行时间) : 7200 hours /year•Cost of reagent (还原剂单价) : 160 Euro/ton (for each reagent)
Reagent还原剂 Reduction
Consumption year [ton]
每年耗量Estimated cost /
year
Urea 40% 25% 3168 € 506.880,00
Urea 40% 55% 7524 € 1.203.840,00
NH4OH 25% 25% 1029 € 164.586,24
NH4OH 25% 55% 2424 € 387.878,40
ReductionCost
saving/year
25% € 342.293,76
55% € 815.961,60
6) DENOX TECHNOLOGY脱硝技术选择
CONCLUSION结论
• SNCR technology with ammonium-hydroxide capable to meet
most stringent NOx reduction needs
使用氨水的 SNCR 技术能够满足最严格的 NOx 的降低需求
• SCR much more expensive. Only a few installations in the world
SCR 投资和运营成本过高。全球范围内仅仅有少量的安装
China representation大中华区全权代表
Petro Miljö AB(SNCR)
TECHSPRAY (Coopertor in China)
上海泰欣( PM 大中华区 SNCR 唯一技术集成商)
HK香港
PRC大陆 ·
MACAO澳门
TAIWAN台湾
THANKS FOR YOUR ATTENTION
Xiamen 29 October 2011Bengt Hellmansson
Petro Miljö AB
top related