civil technical quiz
Post on 22-May-2015
2.030 Views
Preview:
DESCRIPTION
TRANSCRIPT
CIVILTECHNICAL QUIZ – 2K14
ROUND 1
1.) Pycnometer method for water content determination is more suitable for a.) Clay b.) Sand c.) Loess d.) Silt
ROUND 1
2.) In stokes law ,the terminal velocity of particle is
a.) proportional to radius of particle b.) proportional to square of radius c.) inversely proportional to square of radius d.) inversely proportional to radius
ROUND 1
3.) Pretreatment of soil to remove organic matter by oxidation is done with
a.) Sodium Hexametaphospate b.) Oxygen c.) Hydrogen Peroxide d.) Hydrochloric Acid
ROUND 1
4.) Toughness index of soil is ratio of
a.) Plasticity index to Flow index b.) Liquid index to Flow index c.) Consistency index to Flow index d.) Shrinkage index to Flow index
ROUND 1
5.) Honey combed structure is found in
a.) Gravels b.) Coarse sands c.) Fine silts and sand d.) Clay
ROUND 1
6.) Weakest bond in soils
a.) Ionic bond b.) Covalent bond c.) Hydrogen bond d.) Secondary valence bond
ROUND 1
7.) Coefficient of permeability of soil
a.) Increases with increase of temp b.) Increases with increase of temp c.) Increases with decrease in unit weight of water d.) Decreases with increase in void ratio
ROUND 1
8.) Lime stabilization is generally used for stabilizing
a.) Gravels b.) Sands c.) Clays d.) All
ROUND 1
9.) Minimum surcharge for C.B.R test is
a.) 2.5 kg b.) 3.5 kg c.) 4.5 kg d.) 5.5 kg
ROUND 1
10.) The formation which contains water but is not able to transmit is called
a.) Aquifer b.) Aquiclude c.) Aquifuge d.) Aquiguard
ROUND 2
1.) If a member is subjected to an axial load ,the plane normal to the axis of loading carries a.) Minimum normal stress b.) Maximum normal stress c.) Maximum shear stress d.) Minimum shear stress
ROUND 22.) A cantilever of length ‘L’ carries a point load ‘W’ at free end.The B.M diagram is a.) Parabola with maximum ordinate at centre of beam b.) Parabola with maximum ordinate at cantilever end c.) Triangle with maximum ordinate at free end d.) Triangle with maximum ordinate at cantilever end
ROUND 2
3.) The B.M at a section , where shear force is zero, will be
a.) Zero b.) Maximum c.) Minimum d.) Either maximum or minimum
ROUND 2
ROUND 2
ROUND 2
6.) A short column of rectangular section carries a point load (W) actin with an eccentricity (e).The shape of kernel area would be a.) Square b.) Rectangle c.) Circle d.) Rhombus
ROUND 2
7.) Two shafts, one solid and one hollow have same length, material and weight.
The hollow shaft compared to solid shaft is
a.) More strongb.) Less strongc.) Have same strengthd.) Cannot determine
ROUND 2
8.) The maximum shear stress in a thin cylindrical shell when subjected to internal pressure P is equals to
a.) PD/4tb.) PD/8tc.) PD/2td.) PD/t
ROUND 2
9.) The equivalent length is equal to half of actual length of a column with
a.) one end fixed and other end freeb.) both ends fixedc.) one end fixed and other end hingedd.) both ends fixed
ROUND 2
10.) In a simply supported beam, temperature variations produces
a.) Large stressesb.) Small stressesc.) Zero stressd.) None
ROUND 3
1.) The green house effect is due to :
a.) penetrability of low wavelength radiations through co2
b.) penetrability of low wavelength radiations through o3 layer
c.) impermeability of long wavelength radiations through co2 of the atmosphered.) impermeability of long wavelength radiations through o3 layer
ROUND 3
2.) Chlorofluorocarbons release a chemical harmful to ozone is :
a.) Fluorine b.) Sulphur dioxidec.) Chlorined.) nitrogen peroxide
ROUND 3
3.) Ozone day is observed on : a.) September 16 b.) January 3 c.) November 10 d.) March 26
ROUND 3
4.) Motor vehicles act was introduced in a.) 1949 b.) 1939 c.) 1929 d.) 1934
ROUND 3
ROUND 3
6.) The darker zone in lakes where light penetration is negligible is called
a.) Euphotic zone b.) Benthic zone c.) Littoral zone d.) Limnetic zone
ROUND 3
7.) B.O.D / C.O.D ratio will always be
a.) equal to 1 b.) less than 1 c.) more than 1 d.) none
ROUND 3
8.) The minimum value of camber provided for thin bituminous surface hill roads, is a.) 2.2 % b.) 2.5 % c.) 3.0 % d.) 3.5 %
ROUND 3
9.) Border Roads Organisation for hilly regions, was formed in a.) 1947 b.) 1954 c.) 1958 d.) 1960
ROUND 3
10.) Reinforcement in cement concrete slab of road pavements, is placed
a.) Longitudinally b.) Transversely c.) Longitudinally and Transversely d.) In form of welded mesh wire
ROUND 4
1.) Kinematic viscosity is defined as equal to
a.) Dynamic viscosity x density b.) Dynamic viscosity / density c.) Dynamic viscosity x pressure d.) pressure x density
ROUND 4
2.) Poise is the unit of
a.) Mass density b.) Kinematic viscosity c.) Viscosity d.) Velocity gradient
ROUND 4
3.) The resultant hydrostatic force acts through a point known as
a.) Centre of gravity b.) Centre of buoyancy c.) Centre of pressure d.) Centre of point
ROUND 4
4.) The flow in pipe is laminar if
a.) Reynolds number is equal to 2500 b.) Reynolds number is equal to 4000 c.) Reynolds number is more than
2500 d.) None of the above
ROUND 4
5.) Pitot-tube is used to measure
a.) Pressure b.) Flow c.) Velocity at a point d.) Discharge
ROUND 4
6.) Hydraulic gradient line (H.G.L) represents sum of a.) Pressure head and Kinetic head b.) Kinetic head and datum head c.) Pressure , kinetic and datum head d.) Pressure head and datum head
ROUND 4
7.) Maximum efficiency of power transmission through pipe is
a.) 50 % b.) 66.67 % c.) 75 % d.) 80 %
ROUND 4
8.) Unit Hydrograph theory was enunciated
by a.) Merril Bernard b.) W.W.Horner c.) Le-Roy K.Shermen d.) Robert E.Horten
ROUND 4
9.) The surface Run-off is the quantity of water a.) Absorbed by soil b.) Intercepted by buildings and vegetative cover c.) Required to fill surface depressions d.) That reaches the stream channels
ROUND 4
10.) The best instrument for measuring the
velocity of a stream flow is
a.) Pitot tubeb.) Price current meterc.) Surface floatd.) Sub-Surface float
ROUND 5
1.) The reduced bearing of a line is N 87° W.
Its whole circle bearing is
a.) 2830
b.) 2730
c.) 30
d.) 930
ROUND 5
2.) The first reading from a level station is
a.) Fore sightb.) Intermediate sightc.) Back sightd.) Any sight
ROUND 5
3.) Back bearing of a line is equal to
a.) Fore bearing ± 90°b.) Fore bearing ± 180°c.) Fore bearing ± 360°d.) Fore bearing ± 270°
ROUND 5
4.) The longitudinal section of the surface
of bubble tube is
a.) Straightb.) Circularc.) Parabolicd.) Elliptic
ROUND 5
5.) Moist curing of the exposed surfaces of concrete is done at least for
a.) 3 daysb.) 5 daysc.) 7 daysd.) 11 days
ROUND 5
6.) For battened struts, the effective length
is increased by
a.) 5 %b.) 7.5 %c.) 10 %d.) 12.5 %
ROUND 5
7.) Which of the following is not an isotropic material
a.) Woodb.) Goldc.) Brassd.) Fine grained material
ROUND 5
8.) Which of the following is not applicable for assumptions in strength of materials
a.) The material should be continuousb.) The material is isotropic and homogeneousc.) Super position principle is
applicabled.) Self weight is considered
ROUND 5
9.) Diameter of a rivet hole is made larger than the diameter of the rivet by
a.) 1.0 mm for rivet diameter upto12 mm
b.) 1.5 mm for rivet diameter exceeding 25 mmc.) 2.0 mm for rivet diameter over 25 mmd.) None
ROUND 5
10.) As carbon content in steel increases ,
then
a.) Toughness increasesb.) Ductility increasesc.) Hardness decreasesd.) Brittle increases
ROUND 6
1.) Which company’s logo is this
ROUND 6
2.) Name this equipment used in surveying
ROUND 6
3.) Name this bridge which is in Newyork and one of oldest suspension cables
ROUND 6
4.) It is a building company . Guess it
ROUND 6
5.) Name this surveying equipment
ROUND 6
6.) Name this company which produces oil
ROUND 6
7.) Name this company which is a reputed real estate developer
ROUND 6
8.) This building is of 102 stories and is situated in new york.It is also famous for Hollywood shootings. Name it
ROUND 6
9.) Name this equipment used in concrete
technology laboratory
ROUND 6
10.) This is an equipment used in testing of
soils. Name it
top related