ece-321 introduction 2 telecommunication · 2014. 2. 3. · introduction 2 telecommunication . i...

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

1

ECE-321

INTRODUCTION 2 TELECOMMUNICATION

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

2

CONTENT

1

RF wave propagation.

Antennas for HF, VHF, UHF and

microwaves.

Noise in Communication Systems.

Link Budget Analysis.

Fundamentals of Radar Systems.

Fundamentals of Satellite Communications.

Fundamentals of Wireless Communications.

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

3

Weekly Calendar

1

Weekly Calendar of Lectures

Week Topics Remarks

1, 2 RF wave propagation

2, 3 Antennas for HF, VHF, UHF and microwaves

4 Noise in Communication Systems

5 Link Budget Analysis

6, 7, 8 Fundamentals of Radar Systems

9, 10, 11 Fundamentals of Satellite Communications

12 -15 Fundamentals of Wireless Communications

Final Exam

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

4

MARK DISTRIBUTION

1

LAB(SIM) LAB(EXP) HWs Attendance+ Participation Quiz Midterm Final Exam

10 10 10 10 10 20 30

Mark Distribution EE321

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

5

CHAP1

COMMUNICATION SYSTEM

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

6

source: originates a message

transmitter: converts the message into a signal that can be transmitted over a channel

Channel: transport of the signal over a certain medium (e.g. wire, optical fiber or a radio link)

Receiver: converts the received signal back into a readable message

destination: end user

I-THE BLOCK DIAGRAM

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

7

Sources of Information

1. Voice Microphone

2. Image Camera

3. Data Computer

Electrical

Signal

Types of Channels

1. Free space wireless comm.

2. Cables

3. Optical fibers Wire Comm.

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

8

2) Transmitter : Modifies the baseband signal for efficient

transmision. The transmitter consists on preamphizer, sampler,

Encoder, modulator and Amplifier

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

9

4) Transmission Medium Channel

Pair of copper wires

Coaxial cable

Radio link

Light in optical fiber

Light in air

Waveguide

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

10

1

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

11

II Transmission Impairments

The transmission signal is subjected to the following

undesirable effects created by the transmission channel

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

12

1. Noise

Is defined as random and unpredictable electrical signals

produced by natural processes both internal and external

to the system

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

13

External Noise

Man-made noise generated by contact

switches

Automobile ignition Radiation

Flurescent lights

Electrical Storms

Solar radiation

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

14

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

15

Internal Noise

Thermal motion of electrons in conductors

Random Emission diffusion or recombination of

charged carriers in electronic devices

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

16

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

17

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

18

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

19

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

20

Signal to Noise Ratio (SNR)

Signal Power

By definition SNR = -------------------------

Noise Power

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

21

2. Attenuation

Attenuation is defined as the reduction in the signal strength

as it travels along the transmission medium. It is also called

“ Transmission Loss”.

Attenuation is directly proportional to distance and frequecy

Rain and snow also increases attenuation where the atmosphere

used as a transmission medium.

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

22

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

23

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

24

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

25

3. Distortion

The waveform perturbation caused by the imperfect response

of the system is called distortion.

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

26

4. Interference

Interference results from the combination of or two or more signals

In the same frequency band.

As a result of interference, the signals sometimes add up to create a

more powerful signal and sometimes canal each other to create a

weaker signal

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

27

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

28

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

29

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

30

5) Receiver Reponses the signal from the channel by undoing

the signal modification made at the transmitter and the channel.

The receiver may consists on a Demodulator, a decoder a filter

a deemphasizer and an amplifier

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

31

6) destination The unit to which the message is communicated.

It can be the user , a computer .

The output signal is similar to the original input message.m

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

32

III -TRANSMISSION MODES

1. Baseband Transmission Mode

2. Passband (BroadBand)Transmission Mode

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

33

1. Baseband Transmission Mode

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

34

2. Passband (BroadBand)Transmission Mode

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

35

IV MODULATION Baseband signal produced by various information sources

are not always suitable for direct transmission over a given channel .

Therefore the baseband signal is used to modify some parameter

Of a high frequency carrier signal. This process is known as

Modulation

At the receiver the modulated signal must pass through a

receive process called “Demodulation” in order to obtain

The baseband signal

I – term 2013-2014 INTRO 2 TELECOM (EE321)

Prepared by : Dr. Lotfi LADHAR

36

Questions

TOGETHER WE CAN MAKE THE DIFFERENCE

KNOWLEGE IS A POWER

1