error c3451 bishub 350

15. Initial Mode Field Service Ver. 1.0 Aug. 2005

208

biz

hub 2

00/2

50/3

50

Adju

stm

ent / S

ettin

g

15. Initial Mode15.1 Initial Mode Function Setting Procedure

1. Remove the Compact Flash Cover [1].2. Press the Warm Restart switch [2].

3. When “ ” appears at the center on the left-hand side of the screen, enter “3” from the 10-Key Pad.

4. Enter the 8-digit service code and touch [END]. (Default value: 00000000)

NOTE• When [END] is touched after a wrong service code has been entered, the Basic

screen reappears.• At the fourth access after entries of three wrong access codes, [END] is not avail-

able on the screen. It is therefore necessary to turn OFF and ON the Main Power Switch.

• If you forget the service code, it becomes necessary to replace the RAMS Board with a new one. Take necessary steps not to forget the service code.

• The RAMS Board is not available as a replacement part. If it requires replacement, contact Office Printing Support Division by way of CSES.

5. Select a function.

15.1.1 Exiting

• Touch [Exit].

4040F3C533DA

[1]

[2]

4040F3C521DA