fbthg-6566must trunk hinge installation instructions
Post on 31-Mar-2015
74 Views
Preview:
TRANSCRIPT
Important Technical Information:
Fesler Billet makes every effort to ensure that you are provided with the most
accurate and up-to-date technical information. However, all technical
information is approximate and may vary upon application. Fesler Billet is not
responsible for any consequences resulting from manufacture’s technical mid-
year changes. Fesler Billet products should only be installed by a qualified,
licensed auto mechanic experienced in the installation of such products.
Important Anodizing Information:
Anodizing does not produce "flawless" color or finish on any Fesler part order
that way. In fact, you should expect to encounter minor variations (or what
some call "blemishes") in the color and finish in individual pieces. Every Fesler
finish is unique in this regard. Remember, these variations are normal, and do
not affect the performance of the part in any way.
Other Important Stuff You Should Probably Read:
Fesler Billet is not responsible for customer applications that are outside the
normal and intended use of our products, including specific model and year
applications.
Fesler Billet designs all parts off original OEM applications. Due to the vast
array of manufacturers for aftermarket parts, it is possible that you may have to
make some minor adjustments to either our part or your sheet metal in order
for the part to fit properly.
INSTALLATION INSTRUCTIONS
FBTHG-6566MUST
Trunk Hinges
1965-1966 Ford Mustang Fastback
INSTALLATION INSTRUCTIONS
1964-1965 Ford Mustang Fastback Copyright 2011 © by Fesler Productions, LLC. All rights reserved.
Package Contents:
1 pair billet trunk hinges 1 pair lift supports
1 paper template 4 billet washers
4 - 5/16 AN washers 4 - 5/16-18x3/4 socket head bolts
4 – 5/16-18x3/4 button-head bolts 6 – ¼-20x3/4 hex cap bolts
6 – ¼ flat washer 6 – ¼ lock washer
Instructions:
1. Remove the four trunk lid bolts and remove the
trunk lid. Set the trunk lid on a blanket or some
padding.
2. Remove trunk hinge springs. BE CAREFUL THE
SPRINGS ARE UNDER PRESSURE.
a. Remove nut from right side trunk spring.
Slide spring out of the bracket and remove
spring.
3. Remove the two mounting bolts on each of the
stock hinges and remove the hinges.
4. Align the strut bracket
template with lower edge
of hinge support and
back of wheel tub. Mark
three holes and drill to
¼-inch.
5. Install the strut brackets
using the four ¼-20x3/4
stainless button head
bolts and 1/4” washers
and lock washers.
6. Install the new trunk hinge using the four 5/16-
18x3/4 stainless socket head bolts and 5/16 AN
washers.
7. Install the struts with the cylinder body at the hinge
and install strut retaining clips.
8. Tape the area around the trunk lid to help prevent
chipping or scratching the paint.
9. Install and align the trunk lid using the four billet
aluminum washers and four 5/16-18x3/4 stainless
button head bolts.
10. Open and close the trunk lid slowly to check for
rubbing.
top related