how to fabric covered box

Post on 28-Jan-2015

117 Views

Category:

Self Improvement

0 Downloads

Preview:

Click to see full reader

DESCRIPTION

 

TRANSCRIPT

How to:

fabric covered box

kootoyoo…click & stitch

• This is hardly even a “how to”. It’s just a super simple, super speedy bit of fun.

• You’lll need an old kitchen wrap box & cylinder, fabric, nail, embroidery floss, spray adhesive & a hammer

Step 2:

• Pull apart your box.

Step 3:

• Using a small nail & your hammer make a series of evenly spaced holes down the long sides of your box.

Step 4:

• Mine are about 1.5cm apart.

Step 5:

• To make the holes in the ends of the box you just need to refold the box & secure with a bit of tape while you make the holes.

Step 6:

• I just used a piece of scrap wood that fit inside the box to hammer my nails into.

Step 7:

• It’s a good idea to have the holes closer together on the ends as these are actually going to hold the box together.

Step 8:

• Undo all the pieces of tape & lay your box flat.

Step 9:

• Position your box onto your fabric & rough cut to size. Allow a couple of centimetres extra on each of the long sides.

• If you’re using a light coloured fabric you will need to adhere your fabric to the natural side of the box so that you don’t see the branding through the fabric.

Step 9:

• Spray both your box & your fabric with spray adhesive.

Step 11:

• Fold your excess fabric over the long sides as pictured.• Now cut away the rest of the fabric as shown. • Your need to allow a bit of excess fabric on the ends so that you

don’t have raw edges visible.

Step 12:

• Refold your box & secure with bulldog clips or pegs.

Step 13:

• Begin stitching through both layers of fabric & your nail holes…lacing card style.

Step 14:

• I used a running stitch for the long sides (which aren’t structural).

Step 15:

• …and back stitch for the ends of the box. These are actually holding the box together (you could use a little bit of glue too if you’re worried about it).

Finished!

• Finally you could make some twisted cord:http://kootoyoo.blogspot.com/2008/09/how-to-make-twisted-cord.html

or just attach some ribbon to the top of the box. I’ve wound a little spool with the same red floss but a lovely vintage button will work just as well as a closure.

©kootoyoo 2009http://kootoyoo.blogspot.com

top related