instructions for the setting, testing and commissioning of motor

INSTRUCTIONS FOR THE SETTING, TESTING AND COMMISSIONING OF

MOTOR PROTECTION RELAYS

1 .

IMM 7900 RELAY FUNCTIONS

2.

RELAY DESCRIPTION2.1

Digital display2 .2

Nomenclature of the symbols used on the face-plate2.3

Operating curves and block drawing

3.

RELAY SETTINGS3 .1

How to select suitable settings

4.

RELAY CHECKING AND COMMISSIONING4.1

Recommendations4.2

Pre-commissioning checks4.2.1 Thermal unit at twice setting4.2.2 Short-circuit (threshold and operating time) and

unbalance (operating curve)4.2.3 Earth fault (threshold and operating time)4.2.4 Starting characteristic and locked rotor4.2.5 Starts frequency limitation4.2.6 Undercurrent4.2.7 Communications

4.3

Commissioning

5.

ANNEX5.1

Testing a 60Hz relay on a 50Hz supply5.2

Checking the thermal characteristics

This manual only applies to IMM 7960 relays, drawing 25A4, and to 1MM 7990relays, drawing 9987 .

2

The IMM 7960 and 7990 series of relays have been specifically designed to ensure theelectrical protection of high voltage and large low voltage motors .

The digital display provides a readout of certain important data . See table n° 1 for thelist of the different elements .Passing from one code valuee to the next is achieved by pressing the push-but tonIf this push button is held down, the displayed value corresponds to the value of thesetting . After releasing the push-button a new value appears, corresponding to ameasured or calculated value .

3

4

5

6

7

8

9

10

1 1

1 2

13

14

If the test equipment does not incorporate an automatic tripping system, it is advisable tostop the current injection as soon as the expected result is obtained .

15

1 6

17

1 8

19

20

21

22

23