optimum coating solutions optek products cemetitious coatings and additives brief overveiw

OPTIMUM COATING SOLUTIONS

OPTEK PRODUCTSCEMETITIOUS COATINGS AND

ADDITIVES Brief overveiw

OPTEK-H

• AREAS OF USE• Restoration of degraded concrete structures (approved

for use on Heritage sites).• Dust proofing of factory floors.• Surface hardening and abrasion resistance of concrete

surfaces i.e. floors, roadworks, bridge decks etc.• Reinstatement of poorly finished concrete.• Primer for cementitious render. • Water retention agent for new hardening concrete.

PALLONA DAM TASMANIA Spillway wall treated with OPTEK H

OPTEK H

SPILLWAY IN USE AFTER COATING

OPTEK H APPLICATION

OPTEK HBT• OPT-TEK HB-T is a high build thixotropic synthetic fibre reinforced

cement based rheoplastic and non-segregating high strength mortar.• OPT-TEK HB-T is a chemical resistant compound with Migrating

Corrosion Inhibitor designed to protect embedded steel reinforcement and repair damaged or spalling concrete surfaces.

• USES• OPT-TEK HB-T is used for the structural repair of concrete including:• Water treatment and sewage facilities• Marine structures• Bridges• Tunnels pipes outfalls and all below ground structures especially in

harsh ground conditions• Walls, cooling towers chimneys and other concrete repair applications

HBT Benefits• BENEFITS• Can be applied 5mm-50mm in a single layer thickness even in an overhead

application• Overhead, vertical and horizontal applicable in enclosed or open environments, wet

or dry conditions.• Excellent workability• Sulphate resistance• Shrinkage compensated• High early and ultimate strengths• Waterproof, highly impermeable• Sprayable • No added chlorides• Excellent abrasion resistance and durability• High Freeze/thaw, carbonation and sulphate resistance.• Product, when correctly applied, has a life greater than 10 years

OPTEK PLUG

• Opt-Tek Plug is a one-component, rapid

hardening plug composition for permanent stopping of water seepage and pressure leaks through cracks and construction joints in concrete, rock, wooden and masonry structures

• Opt-Tek Plug is a chloride free, ready for use grey powder based on Portland cement with special additives.

OPTEK PLUG USES

• Opt-Tek Plug can be applied to vertical, horizontal and overhead applications:

• static cracks and holes• water storage tanks• basements• building foundations• retaining walls• sewers• below ground car parks• mines• anchoring vertical bolts

OPTEK PLUG Benefits

• • mixed just with water or • can be used as a dry powder• • stop water flow• • fast setting with rapid strength development• • permanent durable repair• • can be installed underwater• • high water-stopping power and hydraulic • resistance• • good adhesion to repaired material• • non-toxic• • easy application

OPTEK RF• OPTEK R-F is a unique brushable penetrative fine cementitious

coating specially designed for waterproofing and protection of old and new concrete against positive and negative water pressure.

• OPTEK R-F prevents the penetration of water and other liquids into

the concrete by causing reactions that produce non-soluble cementitious formations within the pores and capillaries of concrete. These formations grow in the presence of water, blocking pores, capillaries and minor shrinkage cracks, thus waterproofing concrete.

• OPTEK R-F contains a Migrating Corrosion Inhibitor which significantly increases the corrosion protection of steel reinforcement in concrete.

OPTEK RF USES

• Concrete water towers and reservoirs• Water treatment and sewage plants• Swimming pools• Roof decks• Underground tunnels • Basements and foundations• Chemical and fertilizer plants• Bridge pylons, beams and decks• Marine structures• Below ground car parks

OPTEK RF BENEFITS

• When correctly applied as a coating • OPTEKR-F:• Forms an indivisible body with the base concrete• Significantly increases impermeability of concrete• Resists extreme hydrostatic pressure from either positive or negative surface of

the concrete slab • Can be applied to the positive and negative side of the concrete surface• Can seal hairline cracks up to 0.5 mm• Enhances the properties of concrete against reinforcement corrosion• Significantly reduces chloride penetration• Allows concrete to breath• Does not require a dry surface• Has a life greater than 10 years.

BUILDING RESTORATION

OPTEK R• OPTEK R is a unique penetrative cementitious coating specially designed for the

waterproofing, protection and repair of old and new concrete.• OPTEKR prevents the penetration of water and other liquids into the concrete by causing

the reactions those produce the non-soluble cementitious formations within the pores and capillaries of concrete.

• USES• • Concrete water reservoirs• Water treatment and sewage plants• Swimming pools• Roof desks• Underground tunnels • Foundations• Chemical and fertilizer plants• Bridge pylons, beams and decks

SPRAY APPLICATION

OPTEK-R BENEFITS

• When correctly applied as a coating OPTEKR: • Forms an indivisible body with the base concrete• Significantly increases impermeability of concrete• Resists extreme hydrostatic pressure from either positive or negative surface of the

concrete slab • Can be applied to the positive and negative side of the concrete surface• Can seal hairline cracks up to 0.5 mm• Enhances the properties of the concrete against reinforcement corrosion• Significantly reduces chloride penetration• Allows concrete to breath• Does not require a dry surface• Has a life greater than 10 years.

• FOR FURTHER INFORMATION OR TO SEE ALL THE OPTIMUM PRODUCTS PLEASE VISIT OUR WEBSITE AT

• www.optiglo.com.au

• Or contact us by email sabri@optiglo.com.au• tom@optiglo.com.au• Ph 0432 178 934, 0488 017 385