physical communication media

Post on 28-Oct-2014

10 Views

Category:

Education

0 Downloads

Preview:

Click to see full reader

DESCRIPTION

Description of Communication media

TRANSCRIPT

Physical Communication Media

A $oni9680520920

  Physical Communication Media Wire, cable, and other tangible (touchable)

materials used to send communications signals, They are called physical communication media.

The physical layer is concerned with network media and signaling. This layer produces the representation and groupings of bits as voltages, radio frequencies, or light pulses. Various standards organizations have contributed to the definition of the physical,electrical,and mechanical properties of the media available for different data communications.

7.3

Transmission medium and physical layer

Classes of transmission media

GUIDED MEDIA

Guided media, which are those that provide a conduit from one device to another, include twisted-pair cable, coaxial cable, and fiber-optic cable.

Topics discussed in this section:

Twisted-Pair CableCoaxial CableFiber-Optic Cable

Twisted-pair cable

A twisted pair consists of two conductors (normally copper), each with its own plastic

insulation, twisted together.

7.7

UTP and STP cables

RJ45 connector

RJ-45

BNC

UTP connector

Coaxial cable

Coaxial cable (or coax) carries signals of higher frequency ranges than those in twisted-

pair cable, in part because the two media are constructed quite differently. Instead of having two wires, coax has a central core conductor of solid or stranded wire (usually

copper) enclosed in an insulating sheath,

BNC connectors

Optical fiber

A fiber-optic cable is made of glass or plastic and transmits signals in the form

of light.

Fiber-optic cable connectors

UNGUIDED MEDIA: WIRELESS

Topics discussed in this section:

Radio Waves Microwaves Infrared

Unguided media transport electromagnetic waves without using a physical conductor. This type of communication is often referred to as wireless communication.

Electromagnetic spectrum for wireless communication

Radio, satellite microwave,, Bluetooth, and infrared light are all different forms of electromagnetic waves that are used to transmit data

1.Ground Propagation:Radio waves travel through the lowest portion of the atmosphere, hugging the earth.2.Sky Propagation:Higher frequency radio radiate upward into the ionosphere where they are reflected back to the earth.3.line-of-sight Propagation: Very high frequency signals are transmitted in straight lines directly from antenna to antenna.

Radio Waves electromagnetic waves ranging in frequencies between 3 kHz and 1 GHz are normally called radio waves;

Between 3 KHz – 1 GHz. Radio waves use omnidirectional antenna. Radio waves used for multicast communication, such as radio and television. Sky Propagation. This makes radio waves a good candidate for long-distance

broadcasting such as AM radio.

Microwave

waves ranging in frequencies between 1 and 300 GHz are called microwaves. However, the behavior of the waves, rather than the

frequencies, is a better criterion for classification.

Microwaves are used for unicast communication such as cellular telephones, satellite networks, and wireless LANs.

Unidirectional antennas

Infrared waves Between 300 GHz-400 THz Used for short-range communication. Very common with remote control devices, but can also be

used for device-to-device transfers, such as PDA to computer. Line-of-sight propagation.

Infrared signals can be used for short-range communication in a closed area using line-of-sight propagation.

with frequencies from 300 GHz to 400 THz (wavelengths from 1 mm to 770 nm), can be used for short-range communication. Infrared waves, having high frequencies, cannot penetrate walls. This advantageous characteristic prevents interference between one system and another; a short-range communication system in one room cannot be affected by another system in the next room. When we use our infrared remote control, we do not interfere with the use of the remote by our neighbors.

(a) In the VLF, LF, and MF bands, radio waves follow the curvature of the earth.

(b) In the HF band, they bounce off the ionosphere.

THANK YOU

By:- A $oniAmity university

jaipur9680520920

top related