st mes lnl 0006 00_panel tray weld seam (chinathip)

Subject Lessons Learned for Panel Tray & Down-comer weld joint are required

Serial No. ST-MES-LNL-0006-00 Issue Date 2014.10.03

Job No SC2665 Project TOCGC EXPANTION II

OriginatorChinathip C. Team Mechanical Engineer

(STA)

Type LL BP Key Word Panel tray

Problem /Description

There were found joint weld on panel tray & down-comer during inspection at shop because VP drawing not specified.

Cause & Reason

The revision drawing as per SET approved is not required joint weld but actual condition have joint weld. Vendor did not inform when joint weld on panel tray & down-comer is required.Vendor started fabrication by not update drawing & resubmit to approval.

Action / Treatment

Request Vendor to issue nonconformance report (NCR)

Related Department Mechanical, Project, Procurement.

Impact(If Possi-

ble)

Cost None

Schedule □ No □ Below 7 Days □ 7 ~ 14 Days □14 ~1 Month □ Over 1 Month

LESSONS LEARNED / BEST PRACTICE

1

Subject Lessons Learned for panel tray weld joint

Serial No. ST-MES-LNL-0006-00 Issue Date 2014.10.03

Preventive Action

Vendor shall inform & resubmit revised drawing for get approval before final inspection.

Attach-ment

(Photo, Docu-ment)

1. Nonconformance report

LESSONS LEARNED / BEST PRACTICE

2

Adobe Acrobat Document