use c shell - utep · in the scan chains field name you scan chain, scan in and scan out as you did...

Use C Shell

CD to working Directory

Open TetraMax

Initial TMAX Screen

Click Netlist button on top of screen and a window like below will popup

Click Browse to add the tsmc25.v library file and check the Library Module selection. Then select Run

Next click the Netlist button again. Browse to add your synthesized netlist the click Run.

After adding the synthesized netlist your screen should look as follows.

Click on the build button at the top of the screen and a window will popup like this. Click Run.

After building your TMAX window should look as follows. Warnings are expected!!

Click the DRC button at the top of the screen and a window like this will popup.

Click the Quick Stil tab in the DRC window and you will notice a clock option will appear.

Edit the fields as follows 1000, 100, 200, 300, the port name is clk then click Add. Notice clk in Clock List.

Click Scan Chains/Scan Enables Selection and your screen will look as follows.

In the Scan Chains field name you scan chain, scan in and scan out as you did for synthesis the Add.

Notice a chain has been added to the Scan Chain List.

In the Scan Enables field name your scan enable as you did in sysnthesis the click Add.

Notice a scan enable in the Scan Enables List

Click the Run tab and then browse to add your atpg_out file from synthesis. Click Run

After finishing DRC your TMAX shell should look as follows.

Click ATPG button at top of screen. A window will popup that looks as follows.

Click Add all faults option at bottom of window then click Basic Scan.

Notice Fault model options

After Basic Scan your shell should look as follows.

Final step is to export your patterns. Click Write Pat. Tab and a window will popup.

Fill in the Pattern File Name field and select Verilog-S File in the menu. Click Ok.

Your final shell window will look as follows.

If you messed this process up please go back to 1st grade and learn to read again!!!