xcm wireless controller shell version - supremefactory fire version...xcm wireless controller shell...

XCM wireless controller shell version. 2 (with Autofire) installation manual

1.Installation parts:

2.The Xbox 360 wireless controller has 3 different versions, please check before installation.

A: The version 1 of Xbox 360™ wireless controllers.

B: The version 2 of Xbox 360™ wireless controllers.

C: The version 3 of Xbox 360™ wireless controllers.

3.Soldering points。

A:For version 1 of Xbox 360 wireless controllers:

As shown on the following (A,B,C) pictures, solder the providing wires to its place and cut off the PCB.

After soldering

Version 1 ( For Version 2 please see page 7 - 8 and For Version 3 please see page 9 - 11 )

XCM wireless controller shell version. 2 (with Autofire) installation manual

4. Plug the power cord to this socket.

5. As shown in the diagram, push the back of on-live button close to this point, make sure the button working

properly before closing the controller shell.

6. Close the controller bottom, put on the 7 screws then cover the battery pack back to the place.

7. How to turn on the Autofire function：

a. LED light button (on/off the LED light).

b. You can set button(LT,RT) on 360 wireless controller to have the rapid fire function.

For example: Hold the Turbo key and press the "LT" button, that mean the "LT" button now has the rapid fire

function enabled. If you want to remove the rapid fire function, you just need to repeat the process and hold the

Turbo key and press the "LT" button again, that means the rapid fire function has been disabled.

Version 2 ( For Version 1 Please See page 5 – 6 , For Version 3 Please Seepage 9 -11 )

XCM wireless controller shell version. 2 (with Autofire) installation manual

B:For version 2 of Xbox 360 wireless controllers:

As shown on the pictures (D,E,F) ,solder the providing wires to its place and cut off the

specific points.

After soldering the needed connection.

Version 3 ( For Version 1 Please See page 5 - 6 , For Version 2 Please See page 7 - 8 )

XCM wireless controller shell version. 2 (with Autofire) installation manual (page.3)

C:For version 3 of Xbox 360 wireless controllers:

As shown on the pictures (G,H,I,J) ,solder the providing wires to its place and cut off the

specific points.

After soldering the needed connection.