an introduction to emc testing (what can be done with scopes)€¦ · description of standard emi...
TRANSCRIPT
Vincent Lascoste – EMC Product Manager - RSF
An Introduction to EMC Testing
(what can be done with scopes)
Definition of ElectroMagnetic Compatibility (EMC)
10.04.2017 An Introduction to EMS Testing 2
EMC is defined as:
"The ability of devices and systems to operate in their
electromagnetic environment without impairing their
functions and without faults and vice versa, i.e. to
ensure that operation does not influence the
electromagnetic environment to the extent that the
functions of other devices and systems are adversely
affected".
EMC testing is a means of verifying devices and
systems abilities to stand up to this principle…
Interference SourcesINTERFERENCE
SOURCE
natural sources
atmospheric noisegalactic noiseelectrostatic discharge
technical sources
intentional
RF generation
telecommunications
radiocommunicationbroadcastingtelephone
unintentionalRF generation(broadband, low RF energy)
power electronicscomputersenergy distributionignition systemscommutating motorselectric arc welding
non-telecommunications
navigationdiathermymicrowave ovens
Introduction of ElectroMagnetic Emissio
10.04.2017 An Introduction to EMI Testing 5
RF
Le
vel
Frequency
Threshold of Susceptibility
Level of Emission
Safe Distance
for Disturbances
Limit for Emission
Immunity Level
EMI/EMS measurement :
consist to measure un-intended emission of the DUT.
Results are compared to limits, defined by standards
Dut with wanted emission are defined as special cases
The „Working area“ where all devices
run in full & relative compatibility
Propagation of Interfering Signals
10.04.2017 An Introduction to EMS Testing 6
10.04.2017 An Introduction to EMS Testing 7
ı Generally speaking, the EMS test methods are adapted to the frequency ranges
where different coupling phenomena occur…
RF Susceptibility Test Types vs Frequency Ranges
Basic Setup – Bulk Current Injection (BCI) Test
Application example for conducted susceptibility measurements
according to IEC 61000-4-6Current Clamp (BCI)
Bulk-Injection-Clamp
(with calibration fixture)
and Monitoring Clamp
Shielded Room
RF
6dB
Attenuator
LAN
Signal Generator
System Switching
Power Amplifier
PC with
EMC32
FWD REVRF IN
LAN
NRP-Z91
USB
LAN
Basic Setup – Radiated TestApplication example for radiated susceptibility measurements
according to IEC 61000-4-3 up to 6 GHz
Antennas
RF
Anechoic Chamber
Field Probe
Fibre Optic
LAN
PC with
EMC32
FWD REVRF IN
LAN
NRP-Z91
USB
LAN
RF
Power Amplifiers
Signal Generator
EUT
EUT Monitoring - Separate PC + Automatic Data Exchange
USER
“PCMON“
ı Whichever of the discussed methods of testing is used to subject a
device to RF Interference, suitable monitoring of the devices
performance is needed to check for failures….
TEST METHOD
Type of
TRANSDUCTER
DUT
EMI test
receiver
Conducted
EMI
Line
Impedance
Stabilisation
Network
EMI
voltage
LISN
linear
broadband
antennas
magnetic
loop
antennas
military
(non- military)non- military
non- military
(military)
military
&
non- military
Non- military EMI testing
CISPR band A: 9 kHz to 150 kHz
EMI voltage
EMI magnetic fieldstrength
CISPR band B: 150 kHz to 30 MHz
EMI voltage
EMI magnetic fieldstrength
CISPR band C: 30 MHz to 300 MHz
EMI power
EMI electric fieldstrength
CISPR band D: 300 MHz to 1000 MHz
EMI electric fieldstrength
military EMI testing
30 Hz to 40 MHz
Conducted emission
30 Hz to 40 GHz
Radiated emission
EMI/RFI
fieldstrength
EMI
current
Current
clamp
EMI
power
Power
absorption
clamp
Description of standard EMI test setup
10.04.2017 An Introduction to EMI Testing 11
EMC Applications for Oscilloscopes
10/04/2017 EMI debug using R&S RTO 12
Radiated
Interference
EMI
Conducted
InterferencePower Quality
EN55011, EN55012,
EN55013, EN55014,
EN55015, EN55022,
CISPR
EN55011, EN55012,
EN55013, EN55014,
EN55015, EN55022,
CISPR
EN61000-3-2
EN60555-2
EN61000-3-3
EN60555-3
Power Harmonics
Flicker
Measurement
EMS
ESD, EFT and
Burst CalibrationEUT Monitoring
EN61000-4-2
EN61000-4-4
EN61000-4-5
EN61000-4-3
RTO: An powerful tool for EMI/EMS debugging and precompl. applications