bagaimana me-restore flash yang tidak sengaja terdelete
TRANSCRIPT
BAGAIMANA ME-RESTORE FLASH YANG TIDAK SENGAJA TERDELETE
PADA CISCO CATALYST WS-C2924C-XL-EN
BY:DAYWALKER@CNC-108
http://www.ittelkom.ac.id/pinguin
http://iwing.wordpress.com
DISCLIMER: Penulis tidak bertanggung jawab terhadap kerusakan hardware dan software
yang ditimbulkan oleh document ini, document ini ditulis berdasarkan pengalaman pribadi
penulis dan mengacu pada document resmi cisco dengan id 12036 (Recovery From Corrupt
or Missing Software Image on Cisco Catalyst 2900XL and 3500XL Series Switches)
Teledor itu lah yang ada dibenak saya ketika dengan tidak sengaja mendelete flash
pada perangkat cisco catalyst seri ws-c2924c-xl-en. Tadinya saya hanya ingin mendelete
konfigurasi vlan.dat nya saja.
Gambar 1
Dan tidak sengaja mendelete flashnya, ketika direset, divice ini tidak mau boot normal
(terlihat pada gambar 1 diatas), Saya panik saat itu (lebay mode on), saya bertanya kepada
forum indocisco dan bertanya pada mbah google. Akhirnya saya dapat rekomendasi dari
teman saya dan mendapatkan referensi dari cisco dengan document id 12036, Betul sekali,
saya harus mengcopykan flash saya yang terdelete dengan menggunakan bantuan xmodem.
Nah saya akan sharing pengalaman bagaimana cara me-restore flash yang terdelete pada
device tersebut. Langkah-langkahnya adalah sebagai berikut :
1) Unplug the power cable.
2) Hold down the mode button located on the left side of the front panel while you
reconnect the power cord to the switch. Release the mode button a second or two after
the LED above port 1x is no longer illuminated.
3) Enter the commands flash_init and load_helper.
4) Download a new Cisco IOS-only image file from the Cisco Software Center ( registered
customers only) to your PC. Do not download a Cisco IOS image with Cluster Management
Suite (CMS) files. Xmodem transfer is a very slow procedure. It takes longer to copy the
larger images.
5) Copy the image to the Flash using HyperTerminal for Microsoft Windows, or another
terminal software program. The command on the switch is copy xmodem: flash:filename ,
where filename is the name of file that you downloaded. With HyperTerminal, use the
TRANSFER -- SEND FILE option using the XMODEM protocol. Start the XMODEM
download within three seconds. Otherwise, the switch times out the XMODEM copy.
6) When the XMODEM request appears, issue the appropriate command on the terminal-
emulation software to start the transfer. Copy the software image into Flash memory. The
command to issue is switch: copy xmodem: flash:image_filename.
7) An example is shown here.
switch: copy xmodem: flash: c2900XL-c3h2s-mz-120.5.2-XU.bin
8) After the new image has been loaded, boot the new image using the boot flash:filname
command where filename is the name of the file that is downloaded. A sample command
output is shown here.
boot flash: c2900XL-c3h2s-mz-120.5.2-XU.bin
Gambar 2
Gambar 3
Gambar 4
Gambar 5
Ok, teman-teman, mudah-mudahan dapat bermanfaat ^_^. Dan jangan sampai teledor
seperti saya T_T. (akhirnya bisa tidur tenang)