7/30/2019 Bug Detecter Diy 1.02

http://slidepdf.com/reader/full/bug-detecter-diy-102 1/2

 

 Notes:

My site contains a few low power transmitters of one type or another, but until

now no receiver. This circuit can be used to "sweep" an area or room and willindicate if a surveillance device is operative. The problem in making a suitabledetector is to get its sensitivity just right; too much and it will respond to radio

 broadcasts, too little sensitivity and nothing will be heard.

This project has few components, can be made on veroboard and powered from a 9volt battery for portability. My prototype shown below, worked OK on a

Eurobreadboard. 

7/30/2019 Bug Detecter Diy 1.02

http://slidepdf.com/reader/full/bug-detecter-diy-102 2/2

 

Circuit operation is simple. The inductor is a moulded RF coil, value of 0.389uHand is available from Maplin Electronics, order code UF68Y. (See my links page

for component suppliers.) The coil has a very high Q factor of about 170 and isuntuned or broadband. With a test oscillator this circuit responded to frequenciesfrom 70 MHz to 150 MHz, most of the FM bugs are designed to work in the

commercial receiver range of 87 - 108 MHz. The RF signal picked up the coil, and

incidentally this unit will respond to AM or FM modulation or just a plain carrier 

wave, is rectified by the OA91 diode. This small DC voltage is enough to upset the

 bias of the FET, and give an indication on the meter. The FET may by MPF102 or 2N3819, the meter shown in the picture is again from Maplin Electronics, order 

code LB80B and has a 250 uA full scale deflection. Meters with an FSD of 50 or 100 uA may be used for higher sensitivity.

In use the preset is adjusted for a zero reading on the meter. The detector is thencarried around a room, a small battery transmitter will deflect the meter from a fewfeet away.

Circuit Exchange International Return to Radio Circ