bullet proff bunker specificaiton

7/27/2019 Bullet Proff Bunker Specificaiton

1/4

S/No Characteristics Specification(s)1. Assembling Should be conveniently assembled and dismantled

2. Handling Two carrying handles should be provided for convenient

handling

3. Dimension Left Plate Centre Plate Right Plate

(Small/Large) (Small/Large) Small/Large)Height 1200 mm/1900 1200 mm/1900 1200

mm mm mm/1900 mm

Width 700 mm/750 mm 700 mm/750 700 mm/750mm mm

Tolerance + 5 mm shall be acceptable in height & Width.

4. Firing port

5. Fitments

6. Weight of Bunker

7. Colour

8. Locking

arrangements

9. Protection Level

Each plate should have one firing port window of size 175 + 5mm x 125 + 5 mm with adequate overlapping. B.P sliding

shutter from inner side. The height of the firing port shall bedefined by the user.

i) All fitments in the Bunker should be done in such a way that

the proprieties of B.P Steel are not affected.

ii) The joints shall be tested for its B.P property irrespective of the

distance of such joints from the edges.

iii) There should be no gap between the sheets in assembled

condition of Bunker.

Weight of B.P Mobile Bunker consisting all the three plates

with all fitments should not be more than 152 Kgs for small

Bunker and 260 Kgs for Large Bunker.

Colour of the B.P Mobile Bunker should be Camouflage

Pattern.Each plates of the B.P Mobile Bunker should have convenientlocking arrangements for assembling and unlockingarrangements for dismantling.

Each plate should provide following protection level at 90degree angle : -

i) 6 Shots from SLR( 7.62 mm x 51 mm ) at a distance of 10

mtrs.ii) 6 Shots from AK-47(7.62 mm x 39) at a distance of 10mtrs.

Note: - Minimum distance between shots should not be less

than 20 mm. The distance of shots from the edgesshould not be less than 30 mm.


2/4

S/No Characteristics Specification(s)10. Replacement Whenever the B.P Bunker is fired upon and the port shutter

gets damaged, the replacement should be possible.

11. Provision of There should be a provision to attach/detach wheels.Wheels

12. Inspection of the 1% of the total store shall be required to be provided in

item on supply addition with the bulk supply without any additional cost forcarrying out ballistic trial.


3/4

DIAGRAM OF BULLETPROOF BUNKER

(SMALL SIZE)

Not to ScaleAll Dimensions in mm

Handle

205 mm

Sliding shutters

125mm

175mm

870 mm

Right plateLeft plate Middle plate

700mm

for firing port


4/4

DIAGRAM OF BULLETPROOF BUNKER

(LARGE SIZE)

Not to Scale

All Dimensions inmm

Handle

275 mm

Sliding shutters

for firing port125 mm

175 mm

1500 mm

Right plateLeft plate Middle plate

750mm

Dimensions of all the three plates ie. Left, Centre and Right are the same

bullet proff bunker specificaiton

Documents