burners
TRANSCRIPT
![Page 1: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/1.jpg)
Burners
![Page 2: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/2.jpg)
Outline
• Burners• Burner Components• Parts of Burning System• Orientation of Burners• Classification• Solid Fuel Burners• Liquid Fuel Burners• Gaseous Fuel Burners
![Page 3: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/3.jpg)
BurnerA part of the burning system used to burn the fuel in
the presence of some oxidizer.The primary purpose of a burner is to transfer heat
from the combustion products to some type of load.It is important to match the burner to the load to
ensure heat transfer is maximized in order to maximize the system thermal efficiency.
This reduces operating costs and indirectly reduces pollutant emissions because less fuel needs to be combusted for a given production rate.
The heat transfer from burners is often a complicated process because of the turbulent fluid flow, high-temperature chemical reactions, and spectral gaseous radiation.
![Page 4: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/4.jpg)
Burner inside a Furnace
![Page 5: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/5.jpg)
![Page 6: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/6.jpg)
Burner ComponentsNoseBurner tileBodyMounting plateFuel connectionAtomizerPilotObservation Port
![Page 7: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/7.jpg)
Parts of Burning System
Source of airSource of fuelA burnerValves and
proportioning devices
Valve or Proportioning device
![Page 8: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/8.jpg)
Burning System
![Page 9: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/9.jpg)
Orientation of Burners
There can be three orientations of burners1. Hearth fired2. Wall Fired3. Roof Fired
![Page 10: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/10.jpg)
Classification of BurnersMixing TypeFuel TypeOxidizer TypeDraft TypeHeating TypeBurner Geometry
![Page 11: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/11.jpg)
Classification of Burners(According to fuel)
Liquid Fuel Burners
Gaseous Fuel Burners
Solid Fuel Burners
![Page 12: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/12.jpg)
Solid Fuel BurnersSr No Type of Coal
UsedBurner Type
1 High Volatile Short flame with self-induced turbulence
2 Medium Volatile
Short flame with externally induced
burners
3 Low Volatile Long flame or U-type
![Page 13: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/13.jpg)
Liquid Fuel BurnersOil burners are of two types according
to the way with which they may be burnt.
1. Vaporizing Burners2. Atomizing burners
![Page 14: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/14.jpg)
Vaporizing Oil BurnersIn vaporizing burners the volatile fuel is
passed at a low pressure through a tube adjacent to the flame, where vaporization takes place.
The vapour stream issues out of an orifice at a high velocity and entrains primary air.
The fuel-air mixture passes through a mixing tube and burns at the burner head.
![Page 15: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/15.jpg)
Wick-type vaporizing burners A wick raises the liquid fuel from a trough by capillary
action. Radiation from the flame and adjacent hot surfaces
vaporizes the kerosene from the wick head. The vapours enter into an annular space between two
vertical, perforated metallic cylinders and burn in the air drawn through the perforations by natural draught.
The combustion takes place throughout the annular space with a blue flame.
These burners are used as cooking stoves.In ordinary wick-type burners, the burning rate is
controlled by varying the length of the exposed portion of the wick and is less satisfactory.
![Page 16: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/16.jpg)
![Page 17: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/17.jpg)
Pot-type BurnerThere is a fuel reservoir at the bottom, supplied by an oil
line. The oil surface is heated by radiation from the flame and the
hot walls. Vapours mix with the primary air admitted through a central
pillar and perforations in the pot wall. The fuel-air mixture is too rich at the oil surface to support
combustion. Further up, it is diluted with air and becomes inflammable. Flame is supported at the top of the pot. These burners work on natural or forced draught. Superior kerosene or light fuel oil is used. Soot formation necessitates the pot burner cleaning
periodically.
![Page 18: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/18.jpg)
![Page 19: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/19.jpg)
Wall-wiping flameUses coarse atomization before the fuel is
vaporizedA centrally located centrifugal spinner
distributes the oil in the form of a spray of coarse droplets striking the hot stainless steel wall of the burner.
The vapours mixed with the air (which is directed towards the wall by a fan) rises upwards and burns on a stabilizing grill with a blue flame.
The flame burns around the inner circumference of the furnace only, and from this fact gets its characteristic name.
Power requirement is low and operation is noiseless.
Kerosene and light fuel oil are used.
![Page 20: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/20.jpg)
![Page 21: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/21.jpg)
Petromax stovesBurns kerosene.An upward moving fuel jet strikes against a
hot metal surface at a high velocity and the vapours produced burn with a short and intense flame over the metal surface.
The fuel is stored in a small reservoir below the fuel line and the oil pressure is supplied by compressing air into the reservoir by a hand-driven piston.
It has risk of accidents and has noisy operation.
![Page 22: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/22.jpg)
![Page 23: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/23.jpg)
High speed vaporizing burner A high rate of vaporization is achieved
by atomization of the volatile liquid fuel and recirculation of hot combustion gases within the burner.
The burner bears out the difference between vaporizing and atomizing burners.
The combustion chamber receives fuel vapours in the former and fuel droplets in the latter.
![Page 24: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/24.jpg)
![Page 25: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/25.jpg)
Atomizing Oil Burners Atomization of oil creates enormous surface area per unit
weight of the fuel Atomizing burners have an arrangement for the atomization
of liquid fuels before the actual combustion takes place. For atomization, initially a jet or a thin film of liquid is
obtained and allowed to emerge into the open atmosphere at a suitable velocity.
Both the jet and unsupported film are unstable and break up into drops.
Disturbances like swirling of the jet or rotation of the film hastens the disintegration process.
Low viscosity and low surface tension are desirable for ease of dispersion and formation of small drops.
The atomization is assisted by the resistance, friction and turbulence of air.
Local turbulence in the air causes deformation and disruption of the drops.
![Page 26: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/26.jpg)
Types of Atomizing burnersThere are three types of atomizing burners
(differing from one another on the principle of atomization) namely
1. Pressure jet atomizing burner2. Twin-fluid or blast atomizing burner, and3. Rotary atomizing burner
![Page 27: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/27.jpg)
Pressure Jet Atomizing Burners
These are of two types namely
1. The plain orifice type (used for fuel injection in diesel and other internal-combustion engines)
2. Centrifugal swirl type (used in large industrial boilers). In the former, very high pressure of oil up to 350 kg/cm2 or
even higher are used. Much lower oil pressures (7 to 35 kg/cm2) are required in the
swirl type burners. The pressure jet atomizing burners are very quiet, have low
operating cost and power requirement is the lowest of all atomizers.
These are the most widely used of all atomizing burners. The pressure jet atomizers are susceptible to choking by dirt in
the oil. The oil should be strained/filtered for this reason.
![Page 28: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/28.jpg)
![Page 29: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/29.jpg)
Twin Fluid or blast atomizing burners
These burners use air or steam to atomize the oil and are of three main types :
1. low pressure (LP) types using air at 35 to 70 cm w.g.,
2. medium pressure (MP) types using air at 0.4 to 1 kg/cm gauge
3. high pressure (HP) types using air or steam at pressures exceeding 1 kg/cm2 gauge.
Each of these types may again be either ‘inside-mix’ or ‘outside-mix’ type.
![Page 30: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/30.jpg)
![Page 31: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/31.jpg)
Rotary Atomizing BurnersThese have a central stationary fuel line which delivers the
oil to the inner surface of a rotating hollow tapered cup. The cup is rotated (at 3,600—10,000 rpm) and the friction
between the oil and the cup surface causes the oil to rotate with the cup.
The centrifugal force, assisted by the tapering of the cup causes oil to flow towards the brim.
Finally, the oil is flung off in a thin film which disintegrates into fine droplets.
Rotary atomizers can tolerate higher viscosity than the others.
They may however lose atomizing efficiency at low viscosities.
Rotary atomizing burners are extensively used in boilers and small installations.
![Page 32: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/32.jpg)
![Page 33: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/33.jpg)
Gaseous Fuel Burners
There are two methods of burning gaseous fuels:
1. Premix burner or inside mixing type
2. Outside mixing type or diffusion flame burner or nozzle mix type burner
![Page 34: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/34.jpg)
Premix burnerThe gas and air is pre-mixed and then
fired in the furnace chamber.
![Page 35: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/35.jpg)
Outside mixing typeThe gas and air flow separately and mix
together in the furnace as combustion proceeds.
![Page 36: Burners](https://reader036.vdocuments.net/reader036/viewer/2022062511/551d13244979595a198b4877/html5/thumbnails/36.jpg)
Thank You