Catia V5 Interview Questions by Bheemaray

6 Follow ers

Catia V5 Questions in an interview

Hi

Hope you all enjoyed with Sketcher Questions. and most of you know the answers.

I said I ll write answers for the questions in next blog, but I am writing again a

questions. Only reason writing questions is all of of you know answers if any one

dont know the answers please write a comment I ll answers.

My suggestion to a candidates, when the interviewer is asking questions listen it

properly. always the interviewers will try to make you confuse, and the questions

will be asked which never used in real time like questions on Loft (Multi-section

solid, sweep, etc).

The interviewer first question if he is taking on tool is how good you are in CATIA

out of TEN. Next questions will be depending on the grade you answer. As you

know I said 7/10. The questions asked me is at level of 2 or 3. Even before asking

Questions the interviewer should at least 8 or 9 out of TEN.

An average of five I am writing some questions on Part Design .

What is the file extension of a part file?

Which are the Neutral file extensions we can use for the part file?

Can you create a Block using a line/ Is it possible to extrude a Line or Open

profile using PAD.

What is Merge ends in Pad.

Application of Multi-pad.

How do you create a corner chamfer for a bolt/Nut.

What the difference between Merge Rib ends and Merge ends in Rib option.

What are the uses of coupling Curves and Guide curves in Loft/ Multi-section

Solid.

what are the limiting elements in Multi-section Solid.

What is Trim Ribbons in fillet

what is Circle fillet

can you create a hyperbolic fillet in Catia? if yes How?

can you create a sheet metal parts in Part design. How

Can you operate a shell command on Spear.

Is it possible to give a variable distance for a features in rectangular pattern.

What is use of keep specification in Patterns.

what are the differences between Mirror and symmetry.

Can you use symmetry reference as a point or line

can you make a symmetry of single feature out of 10 features.

what is the difference between ADD and ASSEMBLE in boolean operation. (I

can confuse any one for this question)

What is remove lump

Is there any alternate option for remove lump

Is it possible to use pad as an alternative for Stiffener.

what is power copy?

what is UFC?

what is the differences between PC and UFC?

what is the use of Design table? when you use it.

what is the difference between SEW surface and SPLIT.

Can you create Fillet with 12mm radius for a 10 X 10 X10 cube

What is blend corner? when you use it.

what is use of Spline in multi-section solid

what is the alternate option for Intersect Boolean option.

How do you create a negative Polarity body in Part design?

for Sketcher Questions if you need any answer let me know. and Hope you all

good in part design prepare these questions before attending an interview. If you

need answers write your comment here I ll answer your comments.

All the best for your next interview..

Last updated on August 28, 2013