certified wireless technician
TRANSCRIPT
Certified Wireless TechnicianCWNP CWT-100
Version Demo
Total Demo Questions: 10
Total Premium Questions: 60
Buy Premium PDF
https://dumpsboss.com
DumpsBoss - Pass Your Next Certification Exam Fast!dumpsboss.com
QUESTION NO: 1
What can occur when two copies of a signal wave arrive at the receiver at the same time, but 180 degrees out of phase which each other?
A. Increased signal amplitude
B. Bits may be added to the total count
C. Increased signal strength
D. Signal nulling or cancellation
ANSWER: D
QUESTION NO: 2
You configured an AP for 802.1X/EAP authentication. You also configured several clients for the same. The clients cannot authenticate to the WLAN. When you look at the RADIUS server logs, you see that no authentication attempts have been made. Other services use the same RADIUS server without problems. At what location should you check the configuration for errors?
A. Clients
B. AP
C. None of these
D. RADIUS Server
ANSWER: B
QUESTION NO: 3
What is a common problem in specialty Wi-Fi devices?
A. The use of 802.11 VHT-only chipsets
B. The use of older, less capable 802.11 chipsets
C. The use of 802.11 DSSS-only chipsets
D. The use of newer, more capable 802.11 chipsets
DumpsBoss - Pass Your Next Certification Exam Fast!dumpsboss.com
ANSWER: B
QUESTION NO: 4
What is entered on the AP and clients to configure WPA2-Personal?
A. A passphrase
B. The IP address of the RADIUS server
C. The actual preshared key
D. The WEP key
ANSWER: C
QUESTION NO: 5
You are configuring WPA2 for use on an AP. What encryption method should be used to ensure the highest security?
A. TKIP/RC4
B. TKIP/AES
C. CCMP/RC4
D. CCMP/AES
ANSWER: D
QUESTION NO: 6
How many non-overlapping 20 MHz channels are available in the 5 GHz frequency band assuming the regulatory domain allows them all?
A. 11
B. 25
C. 24
D. 14
ANSWER: C
DumpsBoss - Pass Your Next Certification Exam Fast!dumpsboss.com
QUESTION NO: 7
You have configured a WLAN profile on a client computer for a hidden SSID network. The SSID operates in both 2.4 GHz and 5 GHz. The profile never connects or even attempts to connect. What is the most likely configuration error in the profile or on the computer?
A. Wrong passphrase
B. Band selection is configured for 5 GHz-only
C. Wrong SSID
D. Band selection is configured for 2.4 GHz-only
ANSWER: C
QUESTION NO: 8
What can be configured in some client devices to encourage them to use 5 GHz APs whenever they are available?
A. Band preference
B. Gaming mode
C. Band selection
D. Roaming aggressiveness
ANSWER: A
QUESTION NO: 9
How many non-overlapping channels are available in regulatory domains in the 2.4 GHz frequency band? Select one:
A. 14
B. 1
C. 3
D. 11
ANSWER: C
QUESTION NO: 10
DumpsBoss - Pass Your Next Certification Exam Fast!dumpsboss.com
What is used as a mid-span Power over Ethernet (PoE) power source equipment (PSE) device? Select one:
A. Switch
B. Router
C. Controller
D. PoE injector
ANSWER: D