checklist flows
DESCRIPTION
CHECKLIST FLOWS. The main purpose of a FLOW is provide a safe, time efficient manner to start and operate the airplane using a pattern to follow. ALL flows are done from memory and should always be verified by the FAA checklist found in the PIM (Pilot Information Manual). STARTING ENGINE FLOW. - PowerPoint PPT PresentationTRANSCRIPT
CHECKLIST FLOWSCHECKLIST FLOWS
The main purpose of a FLOW is The main purpose of a FLOW is provide a safe, time efficient manner provide a safe, time efficient manner to start and operate the airplane to start and operate the airplane using a pattern to follow.using a pattern to follow.
ALL flows are done from memory and ALL flows are done from memory and should always be verified by the FAA should always be verified by the FAA checklist found in the PIM (Pilot checklist found in the PIM (Pilot Information Manual)Information Manual)
STARTING ENGINE FLOW
Fuel Selector •Verify On
Parking Brake •Set
Alternate Air •Verify OFF (pushed in)
Fuel Boost Pump Mode Switch
*note: lever-lock switch (must pull out on switch before placing in desired position)
•Verify Set to AUTO
Master Switch (ALT & BAT)
*note: ALT FAIL light will illuminate
until engine is running
•ON
Annunciator Lights
*note: Verify ALT FAIL, STARTER ENGAGED
& PITOT HEAT lights illuminate
•Push down to test
VM1000
*note: oil & fuel pressure may have values if residual pressure exists
•Volts>11.4 / Amps 0 /
•Oil & Fuel Pressure 0
FADEC B & FADEC A Power Switch
*note: lever-lock switch (must pull out on switch before placing in desired position)
•ON
Ignition Key •Turn to Left (L) and listen for Fuel Boost Pump
*note: fuel pressure should read approx. 30-32psi on VM1000
Health Status Annunciator (HSA)
•Push to TEST/ set to HIGH
*note: Verify all HSA lights and WOT light illuminate
Throttle•Full Forward, Verify WOT light ON
•Back to stop, ¼” open
Turn Key to START
AFTER START
Throttle•1000 RPM
Lights
Cockpit Rheostat Switches
Landing Light- ON / Strobes- ON / Position Lights- as required
Set to desired intensity
VM 1000
Verify within limits
Avionics Master •ON
Flaps
verify 0 degrees
Transponder
Standby
Flight Instruments/ Comm / Nav Aids- CHECK/SET
Fuel Boost Pump Mode Switch
As required
YOU HAVE NOW SUCCESSFULLY YOU HAVE NOW SUCCESSFULLY STARTED THE AIRPLANE STARTED THE AIRPLANE
AND ARE READY TO TAXI AND ARE READY TO TAXI OUT TO THE RUN UP AREAOUT TO THE RUN UP AREA