taken from http://intro.chem.okstate.edu/HTML/SCH4.HTM

Go to Main Index

AP Chemistry by Satellite LectureguideStudent EditionThermochemistryChapter 4

Objectives

Following your study of this chapter, you should be able to

1. define the terms thermodynamics and thermochemistry.2. describe the kinetic and potential energy and calculate the

amount of kinetic energy of amoving object.3. state the unit conversion relating joules and calories.4. describe the difference between temperature and heat, and

between mechanical workand heat.5. distinguish between the system and the surrounding in a

chemical process.6. define the terms exothermic and endothermic as they apply to

chemical reactions.7. define the terms specific heat and heat capacity and use both

concepts to calculate heatflow.8. draw a coffee-cup calorimeter and label the important parts.9. calculate heat flow in a coffee-cup calorimetry experiment.10. draw a bomb calorimeter and label the important parts.11. calculate heat flow in a bomb calorimeter experiment.12. state the first law of thermodynamics.13. write the mathematical equation defining the internal energy

change in a chemicalreaction.14. calculate the internal energy change for a chemical process in

terms of heat flow andwork.

15. write the mathematical equation for heat flow in chemical reactions at constant volumeand constant pressure.

16. define the term enthalpy (H) and distinguish it from internal energy (E).

17. list the important characteristics of enthalpy of a chemical reaction.

18. describe and recognize state functions.19. calculate the enthalpy change in a chemical reaction using

Hess's Law.20. define the term standard state as it is applied to an element or

compound.21. write a chemical equation describing the formation of any

compound and look up itsheat of formation in table of standard heats of formation.

22. calculate the enthalpy change in any chemical reaction using standard enthalpies offormation.

23. calculate the fuel value (heat of combustion) of a chemical compound using standard

1a. Describe the chemical and physical changes observed in the two reactions which were demonstrated in lecture. Indicate the energy change which occurred in each reaction.

b) Define the term thermodynamics and explain how the term thermochemistry is related to thermodynamics.

2a. Distinguish between the meaning of the terms kinetic energy and potential energy.

3. What is the SI unit for energy? State the unit conversion factor relating the SI unit to calories.

4. Distinguish between the meaning of the terms temperature and heat. Provide an example of two objects that are at the same temperature, yet contain different amounts of heat.

5. Identify the meaning of the terms system and surroundings for chemical reactions. Provide an example distinguishing between system and surroundings.

6. Define the terms exothermic and endothermic. (Using a sketch similar to that used in lecture, show how heat flows between system and surrounding for both types of process.)

7a. Distinguish between the meaning of the terms specific heat and heat capacity. What would be the relative temperature change for two substances of equal mass, but having different specific heats, upon absorbing an equal amount of heat?

8. Label the important components of the coffee-cup calorimeter shown below. What property of a chemical reaction does a coffee-cup calorimeter measure? What type of reactions are studied?

9a. Write the mathematical equation that relates the heat released by the chemical reaction to the heat absorbed by the water and the coffee-cup calorimeter.

10. Label the important components of a bomb calorimeter shown below. What property of a chemical reaction does a bomb calorimeter measure? What type of reaction is studied?

11a. Write the mathematical equation that relates the heat released by the chemical reaction to the heat absorbed by the water and the bomb calorimeter.

Problem Set #6AP Chemistry by Satellite

ALL work must be shown to receive full credit.

PS6.1. Rank the following substances from lowest specific heat to highest specific heat.

C(s), Fe(s), N2(g), H2O(l), Hg(l)

PS6.2. Rank the following substances from lowest heat capacity to highest heat capacity.

1 kg H2O(l), 10 kg Cu(s) cube, 5 kg Fe(s) ball, 5 kg C(s) rod

PS6.3. Below is a table of specific heats for several different metals

Calculate the molar heat capacity for each of the metals. Based on the results

of your calculations, estimate the specific heats of iron and silver.

PS6.4a. How much heat must be absorbed by a 75.0 g sample of water for the temperature to change from 24.5 ºC to 63.8 ºC?

b. Calculate the temperature change if a 75.0 g sample of zinc absorbed the same amount of heat. The specific heat of zinc is listed in problem 6.3.

PS6.5. A 28.4 g sample of an unknown metal was heated to 110.0 ºC and plunged into a 100 g sample of water initially at a

temperature of 24.60 ºC. The final temperature of the mixture was 25.34 ºC. Calculate the specific heat of the metal. Identify the metal.

PS6.6. When 1.000 g of KNO3 is dissolved in 120.0 g of water initially at 24.25 ºC in a coffee-cup calorimeter, the final temperature is found to be 23.44 ºC. Calculate the heat absorbed per gram and per mole when KNO3 dissolves in water. (Assume the heat capacity of the calorimeter is zero.)

PS6.7. Calculate the heat produced per mole of aspirin when 2.216 g of C9H8O4 are reacted with excess oxygen in a bomb calorimeter containing 4.40 kg of water. The temperature change measured is 2.32 ºC. The heat capacity of the calorimeter is 2340 J/ ºC) .

12. State the first law of thermodynamics both in words and using a mathematical equation.

13a. What is the definition of the internal energy of a chemical system? Can the exact amount of the internal energy be calculated for stable chemical systems? Can a change in internal energy during a chemical reaction be calculated?

b) Given the chemical equation

And the diagram

14. Write the mathematical equation that relates the internal energy change to heat flow and work.

15a. Rewrite equation in Exercise 14 for the special case of a constant volume reaction (as in a bomb calorimeter).

b) Rewrite equation in Exercise 14 for the special case of a constant pressure reaction (as in a coffee-cup calorimeter).

16. Define enthalpy in terms of internal energy.

17a. List the three important properties which are important when using enthalpy.

18. Define the term state function.

19a. Define Hess' Law.

20. Define the term standard state as it is used in chemical thermodynamics.

21. Define the term standard heat of formation and provide several examples of chemical equations that characterize a formation reaction.

22a. Define the term heat of reaction and write the mathematical equation used to calculate the heat of a chemical reaction.

23. Define the term fuel value and list several compounds and their respective fuel value.

Problem Set #7AP Chemistry by Satellite

ALL work must be shown to receive full credit.

is -683 kJ. Calculate the heat produced when 2.57 g of CaBr2 are formed.

PS7.3. For which of the following reactions is reasoning in each case.

PS7.4. Given the enthalpy change for the two reactions

PS7.5. Given the following equations;

PS7.6. Using a table of Standard Enthalpies of Formation in your text or another reference book, calculate the enthalpy of reaction for each of the following;

PS7.7. The molar heat of combustion of nitroethane, C2H5NO2(l), to CO2(g), H2O(l) and N2(g) at 25 ºC is -1348 (kJ/mol). Determine the

for nitroethane.

PS7.8a. Given the following thermodynamic data,

Calculate for 1 mol of CaCl2 dissolving in water. Is the dissolution of CaCl2 endothermic or exothermic?

b. If 18.0 g of CaCl2 is added to 100. g of water initially at 23.5 ºC, calculate the temperature of the solution after the CaCl2 dissolves. (Assume no heat is lost to the container or the surroundings and the specific heat of the solution is the same as that of water.)

PS7.8b. (Continued)

PS7.9. Determine the standard enthalpy of vaporization (transition from liquid to gas) for CCl4(l).

Microcomputer software

Computer Aided Instruction for General Chemistry by William Butler & Raymond Hough Drill-and-practice software$40 (4-disk set)

John Wiley & Sons, Inc.605 3rd AvenueNew York, NY 10158(this software may not be available)

Diskette #3 Chemical Thermodynamics