tools and hardwareThis is the list of the tools and hardware that you need.

wood neededThis is the list of wood that you just need.

1. draw the ramp on the floor

For the radius, drill a screw on one side of the “drawing stick” and draw the curve with the pencil.

Draw the side of the ramp on the floor as shown.

2. DRAW THE TRANSITION

3. cut the transition

Layout the transition planks on the ramp drawing and draw the pieces.Draw the curve using the “drawing stick” as in step 01.

Cut the pieces for the transition.

4. put the transition togetherScrew the transition pieces together.

5. build the other transitionsUse the first transition as a template to draw the other two.

6. put the ramp together

Place the transition structures on the floor as shown.Screw the first two planks as shown to achieve a perfect alignment

(The first and last planks will be screwed later)

7. refinementsYou will end up with a smaller space than the plank size. Measure the distance,

cut the plank to the size and screw in.

Cut this piece of wood

continuous step 7

Fill up the edge of the first and last planks to have a smooth ramp entry and screw in.

Put reinforcements on the bottom of the first and second plank at both ends of the ramp for reinforcement.

continuous step 7

Assemble the two planks of each leg first.

8. ASSEMBLE THE LEGS

x3

x3

x3

Place the legs, mark the holes on the transition structures, drill the holes and attach the nuts and bolts.

continuous step 8