Operating instructions

l Container lifting lugsfor top lifting

CLTWLL 56 tonnes (per set of 4)

Columbus McKinnon Corporation LimitedKnutsford Way,Sealand Industrial Estate,Chester CH1 4NZUnited Kingdom

Tel: +44 (0) 1244 375375Fax: +44 (0) 1244 377403Email: sales.uk@cmco.euWeb: www.cmco.eu

Doc. No. 100 Issue No. 01 Feb 2013

GB

The personnel responsible for operation, maintenanceor repair of the product must read, understand andfollow these operating instructions.

The indicated protective measures will only provide thenecessary safety, if the product is operated correctlyand installed and/or maintained according to theinstructions. The operating company is committed toensure safe and trouble-free operation of the product.

CLT LOAD DIAGRAM

Further information and operating instructionsare to be found at www.camlok.co.uk

2) Enter the lug to its full depth.

3) Turn the lug through 900.

4) The lug is now locked in its lifting position.

• REVERSE THESE OPERATIONS FOR THE REMOVAL OF THE LUGS

1) Offer the lug into the slot.

Model Type WLL Lifting Section Weightof per eye dia. perlift set of 4 dia. set of 4

tonnes mm mm kgs

CLT TOP 56 45 39 28

2 3

English

Model: CLTContainer lifting lugs for top liftingWLL 56 tonnes

To suit standard ISO corner boxes.

INTRODUCTIONProducts of Columbus McKinnon Corporation Limitedhave been built in accordance with the state-of-the-artand generally accepted engineering standards.Nonetheless, incorrect handling when using theproducts may cause dangers to life and limb of the useror third parties and/or damage to the hoist or otherproperty.

The operating company is responsible for the properand professional instruction of the operating personnel.For this purpose, all operators must read theseoperating instructions carefully prior to the initialoperation.

These operating instructions are intended to acquaintthe user with the product and enable him to use it tothe full extent of its intended capabilities. The operatinginstructions contain important information on how tooperate the product in a safe, correct and economicway. Acting in accordance with these instructions helpsto avoid dangers, reduce repair costs and downtimesand to increase the reliability and lifetime of theproduct.

The operating instructions must always be available atthe place where the product is operated. Apart fromthe operating instructions and the accident preventionact valid for the respective country and area where theproduct is used, the commonly accepted regulations forsafe and professional work must also be adhered to.

GB

GB Page 2 FITTING INSTRUCTIONS:Self locking and suitable for shackling direct to 4 vertical slings. These lugs are used for lifting with a spreader frameand do not project over the container.

- DO NOT use with 4 leg slings

32t

40t

50tvertical

360

500

Operating instructions

l Container lifting lugsfor bottom side lifting

CLBWLL 32 - 50 tonnes

Columbus McKinnon Corporation LimitedKnutsford Way,Sealand Industrial Estate,Chester CH1 4NZUnited Kingdom

Tel: +44 (0) 1244 375375Fax: +44 (0) 1244 377403Email: sales.uk@cmco.euWeb: www.cmco.eu

Doc. No. 99 Issue No. 01 Feb 2013

GBThe working load limit per set of 4 lugs is 32 tonnes at a maximum angle ofinclination of 500 from vertical. The working load limit is 40 tonnes at maximumangle of inclination of 360 from vertical. The working load limit is 50 tonneswhen used vertically.

Check the marking on the lug. Each lug will be stamped with the maximumload and the angle of working for the set.

The degree of inclination permits the lifting of all but the largest containerswith a simple beam.

These lugs cannot drop out when the slings become slack.

Lugs are handed left and right -• Left hand lugs are marked with an ‘L’• Right hand lugs are marked with an ‘R’

Left hand Right hand

Right hand Left hand

CLB Operating Manual_Layout 1 07/02/2013 10:01 Page 1

Model: CLB

Container lifting lugs for bottom side lifting

WLL 32 - 50 tonnes

To suit standard ISO corner boxes.

2) Enter lug to full extent.

3) Turn lug until spring bolt is

fully engaged in slot.

4) Lug in lifting position.

• REVERSE THESE OPERATIONS FOR THE REMOVAL OF THE LUGS

1) Offer lug into slot. Left hand

bottom side shown.

FITTING INSTRUCTIONS:

Type WLL Lifting Lifting Section Section Weight

sling eye size size per

angle diameter thick deep set

radiused radiused

tonnes 0 mm mm mm kgs

CLB 32 500 45 40 38 18

CLB 40 360 45 40 38 18

CLB 52 00 45 40 38 18

CLB Operating Manual_Layout 1 07/02/2013 10:01 Page 2