PRODUCT LAYOUT

OPERATION GUIDANCE

Indicator lights

Press the switch button to check the capacity of the jump starter.Indicator Lights Unlit 5 Flashing 1 Solid 2 Solid 3 Solid 4 Solid 5 Solid

Battery Capacity 0% 10% 20% 40% 60% 80% 100%

When charging, the indicator lights will flash one by one in sequence. The number of solid indicator lights indicates the battery capacity of the jump starter. When full indicator lights are solid, charging is paused or complete.

PARTS LIST

Part Name Quantity Part Name Quantity

Main Product 1 Switch Cable A 1

Switch Cable B 1 Mobile Phone Connector 8

Notebook Connector 8 Home Adaptor 1

Car Adaptor 1 Jumper Cable with Battery Clamps 1

SPECS

Size: 160x75x28mm Weight: 430g Battery Capacity: 12000mAh Input: 12V 2A

Output: 5V 2A 12V 2A 19V 3.5A

Charging Time: 4 hrs Starting Current: 200A Peak Current: 400A Operating temp: 0~60° C

CHARGING THE JUMP STARTER

1. Plug the home adapter into your house or office wall socket.2. Connect the home adapter to the 12V 1A input port of the jump starter.

or1. Plug the car adapter into the cigarette lighter socket in your car/truck/boat.2. Connect the car adapter to the 12V 1A input port of the jump starter.

TO JUMP START A VEHICLE

1. Make sure the number of indicator lights is at least 3 (60% charged).2. Connect the jumper cable red clamp to the vehicle's positive (+) battery terminal, then

connect the black clamp to the vehicle's negative (-) battery terminal.3. Plug the cord of the jumper cable into the jump start socket.4. Start the vehicle.5. When the vehicle has successfully started, remove the jumper cable from the jump starter

unit, then disconnect the red clamp from the positive battery terminal, followed by the black clamp from the negative battery terminal, all within 30 seconds.

6. Leave the vehicle engine running.

TO CHARGE A MOBILE PHONE OR TABLET

1. Plug switch cable B into the USB 5V 2A output port.2. Select the appropriate connector for your mobile phones or tablet, then connect it to the

switch cable B, and then to your mobile phone or tablet.3. Press the switch button to charge.

TO CHARGE/SUPPLY POWER FOR A NOTEBOOK/LAPTOP

Plug switch cable A into the USB 19V 3.5A output port.Select the appropriate connector, then connect it to switch cable A and to the notebook/laptop.Press the switch button to charge/supply power.

TO SUPPLY POWER TO 12V VEHICLE PRODUCTS OR 12V ELECTRONICS/TVS

Plug the optional switch cable to the 12V 2A output port.Connect the optional switch cable and the 12V vehicle product or 12V electronic device.Press the switch button to supply power.

LED ILLUMINATION

Press the switch button for 3 seconds to start the LED illumination. Then press again to cycle through the different lighting modes in sequence. (Normal, Strobe, SOS, Off).

If you have any issues with the jump starter, do not attempt to repair or adjust the unit yourself. Please contact the Kogan Customer Support Team for information regarding warranty repairs.

For more information regarding this product, please go to http://help.kogan.com/