Available without integrated self-

sealing edges as DELTA®-FOXX!

PR

EM

IU

M

QU

AL

IT

Y

DELTA®-FOXX PLUS

DELTA® protects property. Saves energy. Creates comfort.

■ Construction/rehabilitation

■ Soft sheathing ■ For fully-insulated pitched roofs

Special protection through innovative adhesive strips.Ideal for sarking: breathable and rainproof.Waterproof dispersion coating.High abrasion and tear resistance.Best for temporary roofing. C

ERTIF

IED DELTA ® Q

UALITY

Safe inapplication

Something special for your roof? DELTA®-System offers intelligent solutions all round!

PR

EM

IU

M

QU

AL

IT

Y

■ Outside: DELTA®-FOXX PLUS No more unwanted moisture under your roof. Protect your heat insulation from dust and dirt, driving rain and snow, and moisture. This will keep your heat insulation dry and permanently functional.

■ Inside: DELTA®-REFLEX/ DELTA®-REFLEX PLUS Energy-saving draught and vapour barrier system. Enhances heat insulation by up to 10 %. Stops draught and vapour 100 %.

Special bonding system. Very robust. With ’anti-dazzle‘ coating.

DELTA®-FOXX PLUSExtra quality for sheathed roofs:

■ Integrated adhesive strips along both edges

■ Waterproof and breath-able dispersion coating on a special high-tenacity PET cloth

■ Ideal laying thanks to compacted fibres

■ DELTA®-SCHAUM- BAND for sealing

DELTA®-Quality branded products made by Dörken.

Special bonding system. Very robust. With ’anti-dazzle‘ coating.

DELTA®-FOXX PLUSWindproof thanks to integrated adhesive strips. Roof-window joints are easy to seal. DELTA®-THAN for safe bonding.

Being easy to lay, DELTA®-FOXX PLUS helps keep costs down.

Why not profit from the DELTA®-System?

Needless to say, we have a range of perfect accessories. For detailed information about the DELTA®-System, look up the DELTA®-System guides.

Outside ...

... DELTA®-FOXX PLUS breathable soft sheathing for fully-insulated pitched roofs. Optimum heat insulation from the word Go.

Inside ...

... DELTA®-REFLEX draught and vapour barrier or DELTA®-REFLEX PLUS with integrated self-sealing edges. Energy saver sheet made of tear-resistant, highly flexible four-layer material. Reflects heat and saves heating costs. Protects from electro-smog.

DELTA®-FOXX PLUS ...

■ ... features adhesive strips along both edges: 8 cm wide, the upper strip extends almost across the entire overlap zone, while the 4-cm-wide lower strip is always within the adhesive zone.

■ ... offers full protection even if the overlap does not fit the sheet grid.

■ ... is economical to lay because the adhesive seam is safe on contact and grows stronger as time goes on.

■ ... weighs 270 g/m2 for optimum laying safety.

■ ... is particularly handy for workers because of the heavy cloth backing and the strong coating.

■ ... features an outstanding Sd value of approx. 0.02 m to ensure that any residual moisture will evaporate safely from the roof construction.

■ ... is permanently waterproof because of its special dispersion coating.

■ ... is very robust and highly resistant against impacts, wear, and tearing.

■ ... can be applied easily even to rough board sheathing thanks to its compacted fibre structure.

■ ... features an ’anti-dazzle‘ coating.

■ ... may also be used for sarking.

■ ... is available without integrated self-sealing edges as DELTA®-FOXX.

DELTA®-FOXX PLUS ...

■ ... ensures rainproof sarking in conformance with ZVDH best practices in conjunction with other components of the DELTA® Sys-tem (DELTA®-PREN, DELTA®-SCHAUM-BAND, DELTA®-FLEXX-BAND, and DELTA®-THAN).

■ ... has been judged rainproof by reputable test institutes when installed in combination with other DELTA®-System components.

■ ... remains reliably waterproof even under aggravated test conditions involving 2,700 mm/m2 of rain within 3 hours.

■ ... may be employed even on substandard-slope roofs with an inclination as low as 10 degrees.

■ ... offers permanent safety both as a sheet and in seam, butt, and overlap configurations.

■ ... offers secure protection from dirt and moisture thanks to the two adhesive strips in the overlap zone (see Fig. 1).

■ ... needs to be raised and/or turned over at the outer edge of the wooden sheathing in verges.

■ ... is stretched across ridges, arrises, and valleys. Before put-ting on battens, apply DELTA®-SCHAUM-BAND to the sheets on top of the rafters.

■ ... In the vicinity of the gutter, insert the sheet underneath the fascia board and glue it to the drip plate with DELTA®-PREN (see Fig. 2).

Sheets should be laid out in parallel with the gutter. Sheets end at the edge of the wooden sheathing. Sealing nails with DELTA®-SCHAUM BAND SB 60.

A breathable solution for low-pitched roofs

Rainproof sarking

■ Meets all requirements applying to breathable rainproof sarking ■ DELTA®-SCHAUM-

BAND for sealing

■ Two adhesive strips offer all-round protection

■ Adhesive strips along both edges improve the speed, quality, and cost-efficiency of laying.

■ Innovative strip system in the upper adhesive zone: each individual strip keeps water from pressing in.

■ Optimum bonding without need for overlap precision.

■ The projecting film cover offers additional protection against moisture and dirt in both adhesive zones.

Germany’s number 1 soft sheathing – ultimate safety thanks to two adhesive strips!

■ Standard requests for tender as well as detailed installation instructions for all DELTA®-Products may be obtained at www.doerken.com as pdf files for you to print out and save.

Dörken GmbH & Co. KG

Wetterstraße 58

D-58313 Herdecke

Tel.: +49 23 30/63-0

Fax: +49 23 30/63-355

bvf@doerken.de

www.doerken.com

A company of the Dörken Group

DEL

TA®

is a

regi

ster

ed tr

adem

ark

of E

wal

d D

örke

n AG

, Her

deck

e, G

erm

any.

Dörken makes your life easier – systematically.This is why you are sure to appreciate these handy DELTA®-Accessories:

DELTA®-Accessories  for DELTA®-FOXX PLUS.DELTA®-FOXX PLUS

Technical Data Overview:

Material High-tenacity special PES cloth with a waterproof, breathable dispersion coating and integrated adhesive strips along both edges.

Application For fully-insulated pitched roofs with hard sheathing. Conforms to the ZVDH Product Data Sheet for Soft Sheathing, Class UDB-A. Suitable for temporary roofing.

Flammability Class E, EN 13501-1

Tear strength approx. 370/270 N/5 cm, EN 12311-1

Waterproofing Class W 1 (DIN EN 13859-1)

Sd-value approx. 0.02 m

Service temperature - 40 °C, EN 13859-1, Par. 5.2.9range + 80 °C, EN 13859-1, Par. 5.2.10

Resistance against Pass in the driving-rain test for waterproofing driving rain and soft sheathing, TU Berlin

Ageing resistance Pass in the enhanced ageing test, ZVDH Product Data Sheet, Table 1

Weight approx. 270 g/m2

Roll weight approx. 20 kg

Roll size 50 m x 1.50 m

As weather and insolation conditions may vary, we generally recommend roofing our sheets over promptly. The maximum periods for which they may be exposed to open-air weathering when used as temporary roofing are named in the installation instructions attached to the product.

DELTA®-PRENViscous special adhesive for sealing building elements and the overlap zones of DELTA®-FOXX.

DELTA®-THANPermanently elastic special-rubber car-tridge adhesive. For outside application.

DELTA®-SCHAUM-BAND SB 60Single-faced adhesive tape for sealing nail penetrations between counterbattens and waterproofing sheets.

DELTA®-FLEXX BANDStretchable tape for sealing building components outside and inside.