divisimate quickstart guide for cubase/nuendo · 2019. 12. 11. · divisimate quickstart guide for...
TRANSCRIPT
DIVISIMATE QUICKSTART GUIDE FOR CUBASE/NUENDO 1
DIVISIMATE QUICKSTART GUIDE FOR CUBASE/NUENDO
To connect Divisimate with Cubase/Nuendo you need to do the following:
Setup Divisimate
1) On MacOS: open Divisimate before you open your DAW (the virtual midi ports are only available
when Divisimate is running).
2) Manually activate 4 voices in the lower part of the GUI above the keyboard by clicking on ‘4’ and
connect the 4 voices to the first 4 Out-Ports on the left by clicking in the matrix.
DIVISIMATE QUICKSTART GUIDE FOR CUBASE/NUENDO 2
Setup Cubase/Nuendo
1) Open a session in Cubase/Nuendo and create at least 4 Instrument-Tracks
2) Open the Track Inspector on the left by pressing Cmd+Alt+L / Ctrl+Alt+L
3) Set the first track’s midi-input from ‘All’ to ‘Divisimate Port 01’, the following track’s midi input to
‘Divisimate Port 02’ and so on. To play the preset on the right you need to connect at least Port
01-04.
DIVISIMATE QUICKSTART GUIDE FOR CUBASE/NUENDO 3
4) Record-enable the tracks you want to perform inside your DAW and have fun orchestrating and
composing!
If you want to go back to working the traditional way track-by-track, simply press ‘bypass’ in Divisi-
mate. Divisimate will then send all midi events and CCs directly through to all ports without any
delay or latency.
To avoid duplicates in your DAW when recording single midi/instrument tracks set the midi input to
‘all midi’, go to Studio Setup/Midi, and deselect all inputs but one Divisimate Port being included in
the ‘In All Midi.