HOW TO GET EXTRA LENGTH & GIRTH
with the
Realistic Penis Extender
Xtended Just Right
Copyright © 2015 Doc Johnson Enterprises KIN-0730-04
5
A Sleeve to Please4
Care & MaintenanceWash with warm water and mild liquid soap. Can be turned inside out for cleaning and drying. Let dry completely, then powder the sleeve and extension. Store separately in a cool, dry place.
•••
•
Doc’s Tip for Use
Now your completely customizedXTEND IT ™ is ready to go!
Be sure the head is facing the correctdirection. Pull it on, add a little water-based
glide on the outside before enteringyour partner, and enjoy
Xtensive pleasure!
The Doc recommends cutting the sleeve to mimic the length of your penis for the most comfortable and pleasurable experience.
With your customized extension inside the sleeve (hollow end facing you), refit the sleeve onto your erection, folding over any excess until it fits snugly. Using the ruler, measure the length of the sleeve on your penis, and take note of the measurement.
Remove the sleeve. With itunfolded completely, measurethe sleeve to mimic the same
length as it was on your erect penis.
Trim off the excess lengthfor a custom fit.
Re-apply your ULTRASKYN™ Refresh Powder.HOW TO GET EXTRA
LENGTH & GIRTH7
6
5
4
3
2
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Powder on the inside - Glide on the outside•
Socializewith the Docwww.docjohnson.com/social-media
What you’ll need to Xtend It
What you’ll need to Xtend It
Get Ready1
2
Xtensive Options!3Determine whether you
want 1”, 2”, or 3”of Xtended length!
Get yourself as erect as possible.Using the ruler on the front of the pamphlet, measure the entire lengthof your penis, and take note of the measurememnt.
A solid 1” extension is already built into the head of the sleeve.1
INCH
2INCHES
If you want an additional 1” of length, snip the extension in half, along the indention in the middle – which will give you a total of 2” of added length.
3INCHES
For the maximum 3” of added length, leave the extension piece as-is and insert into sleeve’s tip
Try It BeforeYou DIY!
Use included ULTRASKYN™ RefreshPowder, dust the 2” extension and
inside of the sleeve. Powderingis crucial for easy insertion.
Slip 2” extension all the way into tip of sleeve; hollow end of the extender should face you.
Pull sleeve onto your erect penis,folding over excess of sleeve until it fits
snugly and covers your entire shast.This helps you determine the length
you wish to Xtend It!
Sharp scissors(not included)
Doc’s Advice for Steps 3 & 4
ULTRASKYN™ RefreshPowder
2”ULTRASKYN™
Extension
Hollow ULTRASKYN™
Sleeve
Ruler(on pamphlet)
cm in.
Do not mark sleeve or extension with any type of ink, lead, or paint.Before you trim, remember: you can always cut off more of your XTEND IT™, but you can’t add back on. Cut conservatively and try it on before trimming. NEVER CUT THE XTEND IT™ DURING WEAR/USE.