20'O'~&

Cold App,liedPipe Tape D

High DensityHigh StrengthCorrosion ProtectionPipe Wrap For Newand ReconditioningWork

(1.

Protecto Wrap Pipeline Protection Systems

Protecto Wrap Company for over 35 years hasbeen known for its 'excellence in research anddevelopment, and the high qualit9' of pipelineprotection materials manufactured.Our products meet or exceed corrosionprotective properties of pipe wraps for almostany job specifications and offer you thebenefits of our experience and field service toback up the quality of our products.

I

III

- ----II

200 & 200GTPipe Tape

Compare FeaturesCold Application

Wide Temperature Ranges

High Conformability

Excellent Chemical Stability

Exceptional Mechanical Strength

High Dielectric StrengthLittle Cold Flow

Low Moisture Absorption Rate

Rapid Overlap Bond

ID

i-"

Product DescriptionProtecto Wrap's 200 & 200GT pipetapes are cold applied pipe wraps thatcan be used on all types and sizes ofpipe applications for protection againstmoisture and corrosion and can behand applied using either a spiral orcigarette wrap technique.

200 & 200GT tapes are manufacturedfrom a formulation of premium gradearomatic bituminous resins modified

with synthetic resins.

A special high strength film is bondedto the outer surface of the tapes whichprovides exceptional mechanicalstrength, easy handling, abrasionresistance to rough soil or aggregateparticles.

()A backing separator sheet removeseasily, keeps the bonding surface freshand is removed during application foreasier handling.

Protecto Wrap's 200GT pipe tape isreinforced with an inert reinforcingmaterial for extra mechanical strengthand for applications where extraprotection against abrasion isrequired.

200 & 200GT pipe wraps can beapplied over a wide temperature rangefrom 30°F to 160°F maki ng theseproducts ideal for almost any type ofpipe wrap under most temperature andclimatic conditions.

()

<'

...

200 & 200GTCold Applied Pipe Tape

0 Product Technical DataGeneral PropertiesThicknessTackBond to Primed SteelAdhesion to backing

()

Application Procedures1. Clean the pipe surface to be

wrapped of all dirt, rust andforeign elements by the normalwire brush method.

2. Remove about 2" of kraft paperfrom each end of the mill or yardcoating.

3. Apply Protecto Wrap primer to thecleaned surface with a paint brushand about 2" back on each end ofthe factory coating.

4. Remove the backing separatorfrom the tape for about 6"; whenthe primer becomes tack free,begin the spiral wrap with thefilm covered side of the tape up.

5. Remove and discard thebacking separator from the tapeas you wrap.

6. Use only enough pull on the tapeto conform it properly to irregularsurfaces of the pipe or fitting.

7. When the end of the wrap isreached, release all pull on thetape, cut the tape and if desiredprime the end with ProtectoWrap primer. Smooth the endinto place over the previous lap.

8. Lightly press overlap seams toinsure a firm contact and bond.

9. When using a cigarette wrap for200 & 200GT tape, follow allinstructions above and brush thetack side of the tape lightly withProtecto Wrap primer where itforms a seam, smoothing it downwith your hand.

10. When wrapping pipe to be jackedor pushed under crossings,always start and end joint withtape at a 90° angle to the pipeand use a minimum of primer atthe overlap seam.

0

35:t5 mils and 46:t5 milsExcellentExcellentExcellent

Temperature RangesApplication + 30°F to + 160°FIn Service - 40°F to + 160°F

Moisture Resistant PropertiesTest Value

Moisture Vapor Transmission 0.96 grams/M2-24hrs.Water Absorption .2% Maximum

Electrical PropertiesTest

DielectricStrengthVolume ResistivityInsulation Resistance

Value

1 Thickness-20,000 voltsGreater than 1014 (ohm/em)

(Megohms) 1,000,000

Cathodic Disbondment PropertiesTest Value

Salt Crock Solution-30 Days 1.00 in2 AverageArea of Disbondment

Physical PropertiesTestBackingTensile Strength

Elongation

Tar Softening PointBond to Primed Steel

Chemical Resistance

EnvironmentHot and Cold WaterHot and Cold BrineAlcoholsInorganic AcidsAlkalisBacteriaFungusSoilsMarine LifeRodents

Value

.006" PVC200-250 Ibs.

per sq. in. minimum200 GT-300 Ibs.per sq. in. minimum200-150%200 GT-75%200°F minimumPeel Strength ExceedsTensile Strength

ResistanceInsolubleInsolubleInsolubleResistiveResistiveResistiveResistiveResistiveResistiveResistive

Method

ASTM-E-96BASTM-D-570

Method

ASTM-D-149ASTM-D-257ASTM-D-1000

MethodASTM-G8-72

Methodn.a.ASTM-D-882

ASTM-D-882

ASTM-D-882

ASTM-D-36ASTM-D-903

The information and values listed under Product technical data are averages and should not be considered exact values. Forspecific information andvalues pleasecontact ProtectoWrapCompany,2255 S. DelawareSt., Denver,Colorado 80223 U.S.A.

NominalPipe Size

V2"

1"

1V2"

2V2"

4"

6"

10"

NominalPipe Size

8"

12"

16"18"20"

24"26"

36"

2" Wide TapeW' Lap 50% Lap28.44 18.94

18.08

Pipe Wrap CoverageSpiral Wrap

Lineal Feet of Pipe Coated per Roll4" Wide Tape 6" Wide Tape

W' Lap 50% Lap W' Lap 50% Lap

Cigarette WrapLineal Feet of Pipe Coated per Roll18" Wide Tape 24" Wide Tape

W' Lap 50% Lap W' Lap 50% Lap30.18 15.09 40.24 20.12~4:23 32.B120.42 10.22 27.2318.60 9.3P2.$;801

13.02

13.6212.4010.859.658.68

n'--j

8" Wide TapeW' Lap 50% Lap

Technical Assistance

For application conditions andcoverages not shown in this brochure,or for any information you need,please feel free to call on us fortechnical assistance and information

at any time from our laboratory andfield staff experts.

12.57

12" Wide TapeW' Lap 50% Lap20.12 10.0616.16 8.0813.62 6.8112.40 6,2010.85 5.429.65 4.838.68 4.34

7.286.68

3.643.342.892.55.2.414.82

6.51 17.36

30" Wide TapeW' Lap 50% Lap50.30 25.1540.3934.0431.0027.1324.1321.70

17.03

18.2016.6914.47

13.5612.0710.859.869.108.347.236.386.03

~8.68

7.286.685.79

J

l

4.343.833.627.23 9.64 4.82 12.05

On pipe sizes 10" through 36", "Cigarette Wrap" application is recommended. Quantities shown allow 10% additional materialfor side and top overlaps.

9/87

n I

Protecto Wrap Company2255 South Delaware StreetDenver, Colorado 80223(303) 777-3001Telex 201117

1dJ

200 & 200GT TAPEProducts and Packaging

Roll Rolls per Weight per Squares perWidth Length Carton Carton Carton

2" 50' 24 60 24" 50' 12 60 26" 50' 8 60 28" 50' 4 40 1.339" 50' 4 45 1.5

12" 50' 4 60 218" 50' 2 45 1.524" 50' 2 69 230" 50' 1 41 1.25

8.38 29.34 16.77

19.33 11.05

12.38 7.07 19.45 10.61

8.40 4.80 13.20 7.20 I)

5.18 2.96 8.14 4.44 11.11 5.92