Dimmer debugging
Big dimmer ( hanging dimmer)
◆12ch 10A professional Intelligent Dimmer
◆6ch 20A professional Intelligent Dimmer
◆6ch 10A professional Intelligent Dimmer
Small dimmer ( Din rail mount)
◆6ch 2A dimmer
◆4ch 3A dimmer
◆2ch 6A dimmer
dimmer debugging
scene : is the combination of several
channels on/off status or different brightness
status.
sequence : is the combinations of
difference scenes with some rules or orders
setting up its performance and running time
all the dimmer module can save and control scene, after debugging and
programming, users can choose the different combination with different effects from
the Panel according to their needs. Meanwhile, if the electricity turn off suddenly, our
system can be recover to the before used status automatically.
all the dimmers has sequence function, that makes the lighting control and
lighting effects are more colorful.
Dimmer debugging
Subnet ID and device ID
Can remark accordingly in order to convenient in maintenance and management.
Device MAC (physical ) address
Basica
l info
rmat
ion
Area : devide the devices into several areas, and each area is independent.
Area no.
channels including in Current selected area
Area
con
cept
1, remark to the current selected area2, input the remarks
3, save the setup
Area
rem
ark
Creat
e ar
ea
1, click“area remark”
Channels including in
the area
2, select current area
4, select the will-devide channel
5,to decide which area for the selected
channel
3, create area
Max level: Max brightness of a channel. Range 00 ~ FL.
Note: in the same channel, its lower limit value can not be over the higher limit value, generally speaking, keep the default is ok
Chann
el co
nfigu
ratio
n
Lower limit: if the lower limit setup, when the dimming reach this value, the
channel output is 0. Range 00 ~ 99.
Higher limit : if the Higher limit is setup, when the dimming reach this value, this
channel output is 100%. Range 01 ~ FL
Edit sc
ene
1, select area
2, input scene no., key in a start scene and end scene according to your needs
3, scene remark setup
4, scene setup
Edit sc
ene
3, set up each channel brightness value
2,set up scene run time , that is the time from one bright status to anther status
4, save the scene
1, click the scene setup
Seque
nce
conf
igura
tion
1,sequence remark setup
2, sequence configuration
Sequence step, ie. The invoked scene by each step
Sequence information
Seque
nce
setu
p
1, Sequence mode selecting
2, step setup
3,save setup
Seque
nce
conf
igura
tion
2, step setup, key in the invoked scene No. of each step
3, step time setup
4, save setup
1, sequence step configuration