Modlflow assigmentJ av i e r G a l i n d o s V i c e n te
FR
2
CAD Design
Geometry
FR
4
2 cavities
Partition plane and Mold dimensions
FR
6
Partition line
FR
7
Standart mold
FR
8
Mold dimensions
Cold injection system
FR
10
Sprue, runners, gates
FR
11
Cooling system
Analysis
FR
13
Fill
FR
14
Filling time
FR
15
Quality prediction
FR
16
Air traps
FR
17
Pack
FR
18
Pack
FR
19
Warp
FR
20
Deflection, all effects
FR
21
Deflection, all effects
FR
22
Warpage indicator, all effects
FR
23
Warpage indicator, differential shrinkage
FR
24
Cooling quality
FR
25
Temperature, part
FR
26
Temperature, variance
COST ADVISER
FR
28
Set-up
FR
29
Set-up
FR
30
Set-up
FR
31
Set-up
FR
32
Cost Advisor
FR
33
Cost Advisor
FR
34
Cost Advisor
CONCLUSIONS
FR
36
Conclusions
FR
37
Conclusions• Using this design, the part could be easily filled with a good quality• Filling and warping analysis yield good results.• The cooling system could be improved, because the cooling analysis does not show
very good results.• The cycle time (35s) is acceptable for such a big design• The total cost (4.54€) is quite expensive compared with other plastic parts, but
should be considered the size of this part. The material needed to manufacture this part is high
