7/17/2019 MTM Part Setup Calculator v1.2

http://slidepdf.com/reader/full/mtm-part-setup-calculator-v12 1/1

1 31mm

30mm

7mm

12mm

79mm

4mm

90mm

52mm

0.0000

4.0000

0.1500

0.1500

0.3170

0.4250

1.5000

4.3000

5.0420

4.6170

2.6500

• What is the distance ofthe part face from Z0?(pos. or neg. # is okay)

• What is the length ofthe part geometry? See A

• What is the facingallowance on Spindle 1?See B

• What is the facingallowance for Spindle 2?See C

• What is the width of the

cut off? See D

• What is the cut offclearance? See E

• How far on the partdoes the sub Spindlegrip (what is the Grip Zvalue)? Enter a positivenumber. See F

Total length of the stock(see G):

Part face distance fromspindle face (see H):

Distance to feed the stockon reload:

Amount part sticks out ofSub Spindle (see I):

Spindle 1

Stock in Chuck

Spindle 2

Workspace

Rendered Part

B

A

C

D

E

F

H

G

I

Geometry

Results

 

This image represents a part. The sub spindle isgripping the part and a cut off has been done. The subspindle has not yet returned. You can see the partiallycut part, the geometry, workspace and stock in thechuck as well as the spindles.