ducati scrambler/sixty2 - new rage cycles · ducati scrambler/sixty2 disconnect white connector for...
TRANSCRIPT
INSTALLATION INSTRUCTIONS
[email protected] | 914.339.2929
fender eliminator (tucked)
ducati Scrambler/sixty2
Disconnect white connector for license plate light located in front of swing arm, and re-route underneath bike (picture 1)
Remove wire from two cable clamps under swing arm
Remove 3 hugger bracket mounting screws and take hugger off (picture 2)
Remove splash shield and stock fender (picture 3,4)
Unplug connectors and remove entire fender
Remove storage box from underneath seat (picture 5/6)
To mount belly pan and NRC turn signal bracket to the bike, use 2 stock bolts for lower mounting holes, and 2 supplied M8 bolts underneath tail light. Turn signal bracket sits on top of belly pan (picture 7)
Route all of your wires under seat and plug into stock harness, making sure both signals and plate light are working
1
2
3
4
5
6
7
8
1
2
3
4
5
INSTALLATION INSTRUCTIONS
[email protected] | 914.339.2929
fender eliminator (tucked)
6
7
8
Mount your license plate to the belly pan, and then re-install storage bin (picture 8)
Put your seat back on and ride safe
9
10