e n vy 17 35w specification

Parameter: Size:78.5X50.5X22.5mm Net Weight:107g 5 colors available Thread: 510 thread Capacity: 2100 mAh Adjustable from 2W to 35W 1.0-8.5 V atomizer resistance range: 0.4ohm - 4.0ohm Standard configuration : 1x eNVy 17 1xUSB Cable 1xManual 1xeGo Thread Connector Automatic Voltage/Power Adjusting :Press “+” button or “-” button for two seconds and then loose the button , the system will automatically increase or decrease voltage and power , default unit is 0.1V/0.1W , if need to speed it , just click the +button or - button one more time , changing unit transferred into 1V/1W If need to stop adjusting voltage and power , just click any button on the device . How to charge ： Plug USB Cable into the bottom of battery charging port to charge, the battery icon will keep flashing when charging and stop flashing when fully charged; Pull out the USB charger and the battery icon are off. Character of eNVy 17 Automatic Protection: press the fire button longer than 10 seconds, output shut up automatically, LED will show ’Over 10s’; Atomizer Short-cut Protection: when atomizer short-circuit occurs or without atomizer on it, the OLED screen will show ‘No Atomizer’; Low-resistance Protection: When resistance lower than 0.45ohm or higher than 4.0ohm, screen reflect ‘No Atomizer’; Low Power Alert: When Battery’s power lower than 5%, the power symbol will flash (Please recharging promptly); Low-Voltage Protection: When battery voltage lower than the operating voltage, battery will not work and show ‘Volt Low’ on OLED screen. Precautions: *Do not leave in damp conditions or high temperatures, it may get damaged. * Keep water away (If water goes inside by accident, stop using it in case of short circuit ) *Do NOT use when charging *Do NOT attempt to personally disassemble the built-in precision circuit, disassembling the batteries can cause it scrapped. USB Cable Charge Computer Wall Adapter Operation guidance: Turn on/off: Click the fire button five times on end to turn on and turn off Working: After connecting atomizer,press the fire button while device is on ,then system begin working and timing. Loosen the button , device stop working .If press fire button on end over 10 seconds , it will automatically power off and display "Over 10 S" on the screen VV/VW mode conversion: Click the fire button three times on end when device is on Manual Voltage/Power Adjusting :Click + button to increase or - button to decrease the voltage and power , each click was by 1v/1w the plus direction button the fire button Atomizer Connector the minus direction button the OLED screen www.athenaecig.com eNVy 17 eNVy 17 50.5mm 78.5mm 22.5mm eNVy 17 is all-in-one box mod,designed with changeable 17mm atomizer on it, its compact size and delicate body make it confortable to hold

Upload: joy-ou

Post on 19-Aug-2015

9 views

Category:

Healthcare

2 download

Report

Download

Embed Size (px):

TRANSCRIPT

Parameter:

Size:78.5X50.5X22.5mm

Net Weight:107g

5 colors available

Thread: 510 thread

Capacity: 2100 mAh

Adjustable from 2W to 35W 1.0-8.5 V

atomizer resistance range: 0.4ohm - 4.0ohm

Standard configuration :1x eNVy 171xUSB Cable 1xManual 1xeGo Thread Connector

Automatic Voltage/Power Adjusting :Press “+” button or “-”button for two seconds and then loose the button , the system will automatically increase or decrease voltage and power , default unit is 0.1V/0.1W , if need to speed it , just click the +button or - button one more time , changing unit transferred into 1V/1W If need to stop adjusting voltage and power , just click any button on the device .

How to charge ：Plug USB Cable into the bottom of battery charging port to charge, the battery icon will keep flashing when charging and stop flashing when fully charged; Pull out the USB charger and the battery icon are off.

Character of eNVy 17Automatic Protection: press the fire button longer than 10 seconds, output shut up automatically, LED will show ’Over 10s’;Atomizer Short-cut Protection: when atomizer short-circuit occurs or without atomizer on it, the OLED screen willshow ‘No Atomizer’;

Low-resistance Protection: When resistance lower than 0.45ohm or higher than 4.0ohm, screen reflect ‘NoAtomizer’;Low Power Alert: When Battery’s power lowerthan 5%, the power symbol will flash (Please rechargingpromptly); Low-Voltage Protection: When battery voltage lower thanthe operating voltage, battery will not work and show‘Volt Low’ on OLED screen.

Precautions:*Do not leave in damp conditions or high temperatures, it may get damaged.* Keep water away (If water goes inside by accident, stop using it in case of short circuit ) *Do NOT use when charging*Do NOT attempt to personally disassemble the built-in precision circuit, disassembling the batteries can cause it scrapped.

USB Cable Charge

Computer

Wall Adapter

Operation guidance:Turn on/off: Click the fire button five times on end to turnon and turn offWorking: After connecting atomizer,press the fire buttonwhile device is on ,then system begin working and timing.Loosen the button , device stop working .If press firebutton on end over 10 seconds , it will automaticallypower off and display "Over 10 S" on the screen

VV/VW mode conversion: Click the fire button three timeson end when device is on Manual Voltage/Power Adjusting :Click + button toincrease or - button to decrease the voltage and power , each click was by 1v/1w

the plus direction button

the fire button

Atomizer Connector

the minusdirection button

the OLED screen

www.athenaecig.com

eNVy 17

50.5mm 78.5mm

22.5

eNVy 17 is all-in-one box mod,designed with changeable17mm atomizer on it, its compact size and delicate bodymake it confortable to hold

Kleen Sweep 35W RA 1204 - manuals.minutemanintl.netmanuals.minutemanintl.net/Minuteman/Sweepers...The Kleen Sweep 35W vacuum sweeper has been designed exclusively for sweeping floor

VY Sunglasses Catalogue