e n g i n e e r e d f o r s p e e d

e x o C o m p o n e n t s

exo Model lite / pro 430 lite / pro 480

tent asseMbly 1PC 1PC

Flysheet 1PC 1PC

awning poles 2PCS 2PCS

guy ropes 2M 10PCS 10PCS

guy rope 2.5M 2PCS 2PCS

guy ropes 3M 7PCS 7PCS

pegs 26PCS 26PCS

2

Select a cleared level site and be careful to avoid hanging branches, excessive wind and areas where water could pool under your tent. It may be necessary to dig a trench around your tent to divert water flow.

ESTIMATED TIME: 00:00:30

st

AG

e

Unpack your tent and remove the retaining straps. Release the straps around the top of the frame and let the tent unfold towards the ground.

Stand the tent up in the middle of your chosen site.

exo manual 430 | 480 | set up

stARt

ESTIMATED TIME: 00:00:60

st

AG

e

3

Straighten each of the four legs to lock the frame into position.

Pull the corners out fully so the floor is taught and peg down each corner.

Pull the centre crown upwards until it locks into position.

exo manual 430 | 480 set up

important: adjust the tension on the corner webbing

if required. do not over stretch fabric

ESTIMATED TIME: 00:00:60

4

ESTIMATED TIME: 00:01:00

st

AG

e

exo manual 430 | 480 set up

Pull out the extension tent at the back of the tent and peg out the two corners.

Assemble the extension pole and locate the sleeve at the back of the tent, then feed the pole through.

Secure the extension pole to the ground.

st

AG

e

5 exo manual 430 | 480 set up

finish

Set up the front awning with the two awning poles and secure with guy ropes

Finally, peg out all remaining guy ropes and peg points.

Throw the flysheet over the tent, ensuring that the awning is at the front over the D door. Secure the flysheet to the tent using the buckles on all corners and attach the velcro loops on the inside of the flysheet to the alloy frame.

ESTIMATED TIME: 00:02:00

ESTIMATED TIME: 00:03:00

st

AG

e

Unpeg the guy ropes and pack them away in the zippered pocket.

Take the awning poles and extension poles down.

Release the buckles and velcro before taking the flysheet off the tent then fold it to the same size as the carry bag.

Step inside the tent. Using one hand, grab the handle and pull the centre crown downward. Use your free hand to support the roof poles and step out of the tent as it fully collapses.

6exo manual 430 | 480 | packing up

ESTIMATED TIME: 00:02:00

iMportant: do not stand directly under the centre crown when pulling down the tent.do not force the centre crown downward.adjust the tension of the top corner webbing if required.

ESTIMATED TIME: 00:02:00

st

AG

e

For easy packing, pull the flooring away from the bunched frame to form triangles before rolling. Push the air out when rolling the tent.

Wrap the tent with the retaining straps before placing into the carry bag, followed by the flysheet and remaining accessories.

Undo the remaining pegs and fold the corners of the tent up towards the centre before securing the frame with straps provided.

7 exo manual 430 | 480 | packing up

ESTIMATED TIME: 00:02:00

KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT. This tent fabric will burn if left in continuous contact with an open flame or other heat source. Failure to keep all flame and heat resources away from this tent can result in a fire that can burn, injure or kill you.

NEVER USE ANY FUEL BURNING PRODUCTS INSIDE OR WITHIN PROXIMITY OF THIS TENT.Use of fuel burning products such as stove, gas lantern or gas heater inside or within proximity of this tent will build up accumulation of dangerous concentrations of carbon monoxide, which will cause serious injury or death.

IMPORTANT ZIPPEREnsure all zips are closed during erection of your Companion exo tent. If the zips are open, the tent can be pulled out of shape and create undue stress on the zips when trying to close them.

GUY ROPESAll guy ropes are to be pegged at their full length at all times.

FLYSHEETUse the flysheet provided to keep the tent waterproof in wet conditions.

REMOVING PEGSPegs should be pulled out with another peg, hammer or a peg puller. Never by pulling on the tent. Avoid pegging tent to the point that it stretches the fabric. Overstretching may cause peg loops to tear.

CARE INSTRUCTIONS Always clean and dry your tent thoroughly before packing it away. Storing a wet tent will cause mildew and will dramatically shorten the life of the fabric.

• Only clean your tent with warm water (not hot) and a sponge• Do not store directly on concrete floors.• Do not pack pegs or poles inside your tent. Use separate storage bag.

8exo manual | important info

9 exo manual | important info

WATERPROOFINGCompanion exo tents have the toughest water repellent treatment possible. do not treat the fabric with any type of waterproofing agent. doing so will void warranty.

CONDENSATION The polycotton canvas and ripstop polyester fabrics are coated with acrylic to repel water. This coating reduces air permeability and leads to condensation similar to that which occurs on car windows under certain conditions. This is caused by lower temperatures on the outside of the tent combined with body heat or wet clothing inside of the tent. When this occurs, avoid touching walls to reduce contact leakage. Leaving the doors and windows open will reduce moisture condensation. Some condensation is normal with polycotton canvas and ripstop polyester fabrics and should not be considered as a defect.

MILDEWTo avoid mildew, never put your tent away wet or damp. However, if mildew occurs, use a soft bristle brush or sponge with mild detergent to clean. Let the tent dry in the sunlight and re-apply seam sealer compound on the inside of the seams.

REPAIRING A TEARFor small tears, use a self-adhesive patch kit. We recommend a canvas or awning repairer for larger tears.

FADING FABRICDo not leave your tent set up in direct sunlight longer than it is necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.

FLOOR CONDENSATION Placing a ground sheet under your tent prevents the floor from feeling damp and helps prolong its life. The ground sheet should be smaller than the tent’s floor to prevent rain from running under the tent.

This tent is covered by a two year warranty against faulty materials and workmanship. For warranty or service call Primus Australia on 1300 555 197. You will require original proof of purchase. Your tent will be repaired or replaced at the discretion of Primus Australia. This tent is designed for recreational use only and not as a long term dwelling. This warranty does not cover use of this tent in extreme or abnormal weather conditions, misuse, abuse, neglect or act of God.

If you should have any questions, problems, comments or need spare parts on all models, contact Primus Customer Service Centre on 1300 555 197.

coM

2268

(B)

Dist

ribut

ed b

y Pr

imus

Aus

tralia

Pty

Ltd

. Bun

door

a VI

C 30

83