easy set up instruction easy installation guide · website: (any enquiry or quote) e-mail:...
TRANSCRIPT
Website: www.prints-mart.com(Any Enquiry or Quote) E-mail: [email protected]
Tel: (852)3168-6995 Fax: (852)3741-7896Address: Unit 1305 Hang Wai Industrial Ctr. Blk B 6 Kin Tai St. Tuen Mun, N.T. Hong Kong
Prints-mart Large Format Digital Printing & Trade Show Display (Since 2006)
Email : [email protected] www.prints-mart.com
Step 1: Thoroughly clean surface before installing the �oor decal.
Step 2: Measure and center your decal in desired area.
Step 3: After measuring, tape the �oor decal in place (making sure it looks centered).
Step 4: Remove part of the decal from backing paper.
Step 5: Cut strip of the paper with scissors. Step 6: Squeegee down part of the decal in a ver-tical motion.
Step 7: Remove the rest of backing paper. Step 8: Continue to squeegee the rest of the �oor sticker.
Tools:Masking tape, ruler, hard squeegee and scissors.
Tips:• Apply your floor decal on any smooth indoor floor surface• Make sure there is no dirt or debris on the surface of your floor, otherwise your floor graphics will not stick.• Once the decal has been applied, to the surface of the floor you might see air bubbles (this is normal). Simply poke them with a needle or pin and then press the air towards the hole you poked in the decal. This will allow the air bubble too to de�ate through the hole and then disappear.
Easy Set Up Instruction(Please read before set up)
Applying Floor StickersEasy Installation Guide