easystim tn28-041-qsrm-191101 - yoyo-压缩 · easystim tn28-041-qsrm-191101 - yoyo-压缩 created...
TRANSCRIPT
Relaxation, Anywhere, Anytime
Start HereQuick Start Guide
AUVON ® 3-IN-1 TENS+EMS+Massage Device
A. How to assemble the unit.
1. Upload batteries.
Step 2 Open the lid.
Step 1 Push and press the corner of clip as the picture shows with your left thumb and pull down with your right hand.
Step 3 Upload the batteries.Make sure the ribbon is behind the batteries.
2. Connect lead wires to machine.
3. Connect lead wire pins to pads.
4. Stick pads to therapy area.
Step 3 Upload the batteries.Make sure the ribbon is behind the batteries.
Please know before use
B. How to operate the unit.
Steps to use pre-set modes.
Press any “▼” buttons to unlock the machine when the screen shows a “ ”.(The machine will be locked if you don’t press any button within 30 seconds.)
*Pre-set modes: P1-P10(TENS)&P12-P21(EMS)& P23-P32(Massage)
(1) Press P to select pre-set modes
(2) Press ▲/▼ to increas/decrease intensity.
(3) Press MENU to make waveform flashing.
(4) Press ▲/▼ to select waveform.
Flash
Steps to use manual modes. *Manual modes: P11(TENS)&P22(EMS).
(1) Press P to select manual modes.
(2) Press ▲/▼ to increase/decrease intensity.
(3) Press MENU to make time flashing.
(4) Press ▲/▼ to select times (including continuous time)
Flash Continuous time
(6) If P22(EMS), just repeat above steps of P11 to get started,the user can also adjust rise time, action time, fall time and rest time.
● Please read User Manual 1, page 24 to know what the rise/action/fall/rest time is.● This guide is not intended to replace or substitute the user manual.● Please read User Manual 1 and User Manual 2 complete-ly before using the device.
-------------------------------------------
-------------------------------------------
(5) Repeat press MENU again to set up waveform, frequency, pulse width.
Note: Waiting for 5 seconds or press MENU to save all settings.
------Waveform
----Pulse Width----Time
Frequency ---