epri international conference on corrosion in power...
TRANSCRIPT
CO N FEREN CE A N N O U N CEMENT A N D C AL L FO R PAPERS
EPRI INTERNATIONAL CONFERENCE ON CORROSION IN POWER PLANTS
Supported by Fossil Materials & Repair Program (P87), Integrated Environmental Controls (P75), Combustion Performance & Emissions Control (P71), Water Management Technology (P185)
October 13 – 15, 2015 • Hilton Mission Bay • San Diego, California USA
EPRI International Conference on Corrosion in Power Plants 2 October 13–15, 2015
scopeCorrosion is estimated to cost the U.S. electric power industry over 2.3 billion USD/year. A significant portion of this cost is due to corrosion in power plants. A number of factors have renewed interest in both low- and high-temperature corrosion in power generation equipment including traditional coal-fired boilers, gas-fired boilers, natural gas-fired combined-cycle plants, heat recovery steam generators, geothermal plants, environmental control systems, water treatment systems, aging transmission and distribution infrastructure, and new novel power cycles.
The proposed 2½ day conference sponsored by EPRI is intended to promote a robust exchange of information on the latest research between engineers and scientists on an international scale. Invited keynote speakers and submitted papers will be presented and a conference proceedings will be produced.
Conference participants are likely to include utility engineers and personnel, research scientists, universities, corrosion engineers, service providers, and equipment manufacturers involved in materials selection, corrosion phenomenon, corrosion mitigation, and design in power plant systems.
call for papersEPRI invites abstracts to be submitted that address new and emerging technologies or application of existing technologies that have met with success at their owner sites.
Papers are sought in the following areas: Materials selection, corrosion mechanisms, and industry corrosion experience (case studies). Specific areas include:
Low-temperature corrosion• Flue gas desulfurization (FGD) corrosion• FGD wastewater treatment systems materials selection• Zero liquid discharge (ZLD) systems • Water treatment systems• Under insulation and buried pipe corrosion• Effect of fuel and emissions control additives (bromine,
activated carbon, etc.)• Duct-work, casing, and structural corrosion • Fuel/natural gas handling systems
• Duplex and stainless steel experience in geothermal and renewable applications
• Air heater reliability• Coating performance• Repair and mitigation strategies (coatings, overlays, cathodic
protection, etc.)
High-temperature corrosion topics• Steam-side oxidation and exfoliation• Fireside corrosion of waterwall and superheaters/reheaters• Effect of biomass cofiring• Coating and surface modification for improved corrosion behavior• Refractories for gasifiers
Combined mechanisms• Stress corrosion cracking in waterwalls• Dew point or deliquescent salt corrosion impacts• Improper storage and shipment of high-strength alloys• Fouling and pitting in HRSG economizers• Erosion-corrosion in FRP, coatings, rubber, etc.• Combined corrosion and mechanical performance issues
Future technologies and general topics• Novel material solutions and metallic alternatives• Economics of various materials solutions and quantifying the cost
of corrosion• Open and closed supercritical CO2 cycle material compatibility• New equipment: wet electrostatic precipitators (ESPs), CO2
capture systems, etc.• Fireside corrosion in oxycombustion environments• Liquid/molten salt corrosion for advanced cycles
abstr act submiss ionAbstracts must include the title of the paper, the author's name, and a one-page description. Send abstracts by the dates below to Kandace Callaghan at [email protected]
150–250 Word Abstract Due ..................................January 15, 2015
Speaker Notification of Selection ...........................March 4, 2015
Final Paper/Presentation Due .................................May 20, 2015
EPRI International Conference on Corrosion in Power Plants 3 October 13–15, 2015
tec h n ical co ntacts
John Shingledecker, Project Manager, Principal, Materials and Chemistry Electric Power Research Institute 1300 West W.T. Harris Boulevard, Charlotte, NC 28262 Phone: 704.595.2616 Email: [email protected]
Richard Breckenridge, Program Manager Electric Power Research Institute 1300 West W.T. Harris Boulevard, Charlotte, NC 28262 Phone: 704.595.2792 Email: [email protected]
Nanda Srinivasan, Technical Leader/Project Manager Electric Power Research Institute 3420 Hillview Avenue, Palo Alto, CA 94304 Phone: 650.855.2438 Email: [email protected]
Sylvio Cardoso, Technical Leader/Project Manager Electric Power Research Institute 3420 Hillview Avenue, Palo Alto, CA 94304 Phone: 650.855.1056 Email: [email protected]
schedule of eventsMonday, October 12 6:00 p.m. – 8:00 p.m. Reception and registration
Tuesday, October 13 8:30 a.m. – Noon Conference plenary session 1:00 p.m. – 4:30 p.m. Technical sessions
Wednesday, October 14 8:30 a.m. – 4:30 p.m. Technical sessions 6:00 p.m. – 9:00 p.m. Conference reception and dinner
Thursday October 15 8:30 a.m. – Noon Technical sessions
conference registr ation and feesFor more information and to register for this event, please go to www.epri.com, and select the Events tab on the top of the menu. Select the month of October 2015, and locate this event by date. Click on the link (http://www.cvent.com/d/64qv5f), and follow the simple and easy registration instructions.
EPRI Program Funders (Note: Rate for P87, 75, 185, and 71 Members only) ..............$550
Speakers ..................................................................................$650
All Others ...............................................................................$750 Registration fees will increase by $100 after September 21.
Registration fees include breakfast, lunch, breaks, and all conference events (receptions and conference dinner).
The room reservation deadline is September 21, 2015; after this date, rooms may not be available, or the rates could increase substantially. Please make sure to refer to the EPRI conference by name when making your room reservation to receive the special group rate.
Hilton Mission Bay 1775 East Mission Bay Drive, San Diego, California 92109 Phone: 619.276.4010 Room rate: $189.00 per night + room tax Website: www.sandiegohilton.com
contact infor m at ionFor abstract submission, please contact:
Kandace Callaghan, Technical Assistant II Electric Power Research Institute 1300 West W T Harris Boulevard, Charlotte, NC 28262 Phone: 704.595.2895, Email: [email protected]
For meeting and logistical information, please contact:
Jennifer Kern, CMP, Senior Meeting Planner Electric Power Research Institute 1300 West W T Harris Boulevard, Charlotte, NC 28262 Phone: 704.595.2516, Email: [email protected]
3002004253 August 2014
Electric Power Research Institute 3420 Hillview Avenue, Palo Alto, California 94304-1338 • PO Box 10412, Palo Alto, California 94303-0813 USA 800.313.3774 • 650.855.2121 • [email protected] • www.epri.com
© 2014 Electric Power Research Institute (EPRI), Inc. All rights reserved. Electric Power Research Institute, EPRI, and TOGETHER . . . SHAPING THE FUTURE OF ELECTRICITY are registered service marks of the Electric Power Research Institute, Inc.
The Electric Power Research Institute, Inc.
(EPRI, www.epri.com) conducts research and
development relating to the generation, deliv-
ery and use of electricity for the benefit of the
public. An independent, nonprofit organization,
EPRI brings together its scientists and engineers
as well as experts from academia and industry to
help address challenges in electricity, including
reliability, efficiency, affordability, health, safety
and the environment. EPRI also provides tech-
nology, policy and economic analyses to drive
long-range research and development planning,
and supports research in emerging technologies.
EPRI’s members represent approximately 90
percent of the electricity generated and delivered
in the United States, and international participa-
tion extends to more than 30 countries. EPRI’s
principal offices and laboratories are located in
Palo Alto, Calif.; Charlotte, N.C.; Knoxville,
Tenn.; and Lenox, Mass.
Together…Shaping the Future of Electricity