CubbyCap—Installation Instructions

Thanks for purchasing CubbyCap—A way to transform your Model S cubby! Please read these instructions before you install the CubbyCap. Overview: CubbyCap has been designed for those CCI owners who want to transform their open cubby into a closed storage space. CubbyCap is easily installed and requires no screws, drilling or special tools. IMPORTANT: Please be sure to read and review these instructions, including making a ‘dry run,’ before removing the adhesive tape covering on the hinges (see Step 2 and adhere CubbyCap to your Model S cubby. The automotive adhesive used for the cubby cap hinges and magnetic latch is very strong and cannot be easily removed. Installation. The following installation instructions will enable you to install CubbyCap without difficulty or damage to your Model S cubby.

Figure 1. The CubbyCap

Step 1. If your Model S has an Evannex Center Console Insert (CCI), remove it for easier installation. Step 2. Perform a dry run. Before you remove the adhesive covering (red strips) from the CubbyCap

hinges line up the top, left and right edges of CubbyCap to the inside edges of the cubby box. The sides of CubbyCap should just touch the inside edges of the cubby (see Figure 2a). Then, practice bend the hinges (do NOT remove adhesive) to fit the bottom underside of the cubby (see Figure 2b) frame. Once you’re satisfied with fitment, remove the CubbyCap.

Step 3. Remove the protective adhesive strips from the hinges (Figure 1) and perform Step 2

again. This time, however, the adhesive is “live”, so when you press and bend the CubbyCap hinges into place, they will adhere to the curved front bottom surface of the Model S cubby.

CubbyCap  Installation  Instructions  Evannex  is  not  responsible  for  any  damage  that  might  occur  as  a  consequence  of  these  Installation  Instructions.  Please  

consult  a  qualified  professional  if  you  are  uncomfortable  with  any  of  the  operations  described  herein.  

(a) (b) Figures 2a, b. CubbyCap alignment and hinge placement shown with cubby removed from vehicle (there is no need to remove the cubby, shown for illustration purposes only)

Step 4. Install the magnetic latch plate in the center top inside surface of the Model S cubby (see Figure 3). Before removing the red adhesive covering from the magnetic latch plate, center the plate on the small magnet in the CubbyCap door [centered 4 5/16” (110mm) from inside edge of the cubby] and position it so the front edge of the latch touches the inside straight edge of the cubby top surface (see Figure 3). Note: The brushed aluminum display frame sits above the cubby. Do not align the latch with the aluminum display frame, but rather with the inside straight edge of the cubby top surface (see Figure 3). The intent is to ensure that the magnet in the CubbyCap door will ‘catch’ the plate. Mark the position of the plate with a pencil.

Figure 3. CubbyCap latch alignment shown with cubby removed from vehicle (there is no need to remove the cubby, shown for illustration purposes only) Step 5. Remove the adhesive covering from the latch plate and using the pencil markings, press the latch plate into place for about 5 seconds. Your CubbyCap is now ready for use!